How to Troubleshoot and Replace the Blower Motor on a 2017 Dodge Ram.
Vložit
- čas přidán 10. 08. 2023
- This RAM had a blower motor that did not work and I diagnosed it down to the blower motor itself.
TYC 700308 Replacement Blower Assembly for 2014-2022
amzn.to/451u7wm
DEWALT XTREME 12V MAX* Cordless Screwdriver, 1/4-Inch, (DCF601F2)
amzn.to/3DQTPYC
OTC 3630 Battery Powered Continuity Tester Test Light
amzn.to/3QyjJYy - Auta a dopravní prostředky
TYC 700308 Replacement Blower Assembly for 2014-2022
amzn.to/451u7wm
DEWALT XTREME 12V MAX* Cordless Screwdriver, 1/4-Inch, (DCF601F2)
amzn.to/3DQTPYC
OTC 3630 Battery Powered Continuity Tester Test Light
amzn.to/3QyjJYy
Designed perfectly. This is exactly how hard it should be to swap these. Every other company with a more difficult install is doing it terribly wrong. Bravo on Dodge for this one... Granted, they should just design a blower that never needs changed- but this is the next best thing.
The blowers on the 07-13 Silverado/Sierras are the easiest. Pull down on a tab & twist the motor out. Can change one of those in 5 minutes.
This video was GOD SEND. Very well done bud!
Thanks for the information
Thank you for the Video
I’m going to replace mine Now
Great job!!
Very good information 🙏
I tested my connector and I have power and the control wire is working as you showed it should. I changed the motor and still nothing. Is it possible I bought a bad motor? Or anything else I should check?
Mine just started acting up in last 2-3 days. It's been 100+ here in Iowa. It'll come on and then shutoff come back on and shut off. So I'm hoping it's nothing major but at least I know what to try now. 👍
Was it the motor?
@carsbikestrucks17 no mine was the fuse. Been working ever since.
I think just like you do, always take out the hard screw first….get her done and then cruise to the finish line😊
That's actually a necessity that comes with experience. If you've ever gotten down to the last one and gotten it half way out -- and now your part is dangling and falling down -- and you're still fighting to get to that last 'hardest to get to' screw-- lol.. It can become an ongoing nightmare in a hurry. So saving the 'easiest to get to' for last becomes a natural evolution-- to avoid that struggle that you know all too well, from before. :)
I just replaced mine. It ran for 10 seconds, then nothing.
Got the same blower motor mine has these little medal things on the panels. Should I remove them before installing or do I install them with those medal pieces? Little medal brackets holding on panels. (3 of em)
Can you send me a picture? mechanic737@hotmail.com
I have a 2018 Ram 2500, for some reason the relay for the blower motor keeps failing, I'll replace it and it's good for 6 months then the relay burns up and I have to change it, would a faulty blower motor, or one that is going bad, cause the relay to keep failing/ burning up?
Depending on how the relay is failing could be caused by a blower motor pulling too much current.
Having issues with a 16 no ground just two hot leads on my blower motor .?
So it looks like the black wire should be grounded. If you do not have a ground you need to find out why.
So if im getting nothing at the end of the connector with my test light will it be the connector itself? I removed the connector and tested it from the front end of the pins and I get power to it except from the rear end. What would you say it is? I just installed a new blower motor and nothing. Tested the fuses and all good
Sounds like the controller if you have a manual temp controller, meaning you do not have a digital readout. If that is the case it is probably this part here.
amzn.to/3QptA2r
Where is that located
@@311racer You should be able to follow the wires to it.
I tested my connector and I have power and the control wire is working as you showed it should. I changed the motor and still nothing. Is it possible I bought a bad motor? Or anything else I should check?
I tested my connector and I have power and the control wire is working as you showed it should. I changed the motor and still nothing. Is it possible I bought a bad motor? Or anything else I should check?
You need to make sure you have a good power and ground. And then you need to make sure the control wire is working. If they are then you probably got a bad blower motor or the wrong blower motor. There are blower motors for auto climate controls and manual climate controls.