What if the head lights, need to be adjusted so they are straight? Can you do that with ought taking of the bumper? One of my head light are getting old, to replace the bulbs on a 2014 Town and Country, do I have to take of the bumper?
2 months later... no. reach in and twist out the bulb socket. then remove the connector from the bulb. twist back in. One of the small parking light peanut bulbs went out also. those dont last long.
bro I got mine all taken apart and I am a complete wussy when it comes to disconnecting the wires. What the hell am I doing wrong? I got one out by just pulling hard....now I have cut my fingers all up trying to get the other three connections out ....using fingers, screw driver pillars. Any tips for a dipshit ?
So, unfortunately this is the case many times. Strong hands and slight twisting on the electrical wire connector and not the wires is commonnly needed. Wiggling the connectors and also using small flat head screw drivers or picks to pry them apart or open them up a little. Of course it is possible to damage the connector or wiring so important to be strong and firm but also careful.Many professional techs learn early on the tough balance of strentgh vs not breaking old brittle plastic car pieces.
Why dose everyone skip the light adjustment
Thanks for the video on this. I was able to get this done quickly.
how long did it take u from start to finish?
You forgot adjusting the headlight aiming.
All they have is the headlight socket from the link provided for parts.
Can you tell me how to adjust the front lights
What if the head lights, need to be adjusted so they are straight? Can you do that with ought taking of the bumper? One of my head light are getting old, to replace the bulbs on a 2014 Town and Country, do I have to take of the bumper?
2 months later... no. reach in and twist out the bulb socket. then remove the connector from the bulb. twist back in. One of the small parking light peanut bulbs went out also. those dont last long.
📥I need to get the entire front clip assembly replaced including the lights
bro I got mine all taken apart and I am a complete wussy when it comes to disconnecting the wires. What the hell am I doing wrong? I got one out by just pulling hard....now I have cut my fingers all up trying to get the other three connections out ....using fingers, screw driver pillars. Any tips for a dipshit ?
So, unfortunately this is the case many times. Strong hands and slight twisting on the electrical wire connector and not the wires is commonnly needed. Wiggling the connectors and also using small flat head screw drivers or picks to pry them apart or open them up a little. Of course it is possible to damage the connector or wiring so important to be strong and firm but also careful.Many professional techs learn early on the tough balance of strentgh vs not breaking old brittle plastic car pieces.
The first sentence really put me off....fkkkkkkkkkk
I don't think you have to pull all that loose
Yes, it needs to be done
Not really sure about your plans
I did it yesterday and I pulled the bumper off. Can’t see any other way… 1 hour and a half. 2013 Town and Country
@@soupy107how hard was it?
@@richardresendez2325 not bad. Two guys 1 hour