67 Mustang 4r70w Transmission Swap
Vložit
- čas přidán 1. 12. 2023
- Junkyard 4r70w out of a 2002 V6 Mustang, 351w, Silver Fox Performance manual valve body, Circle D Specialties torque converter, Billet Automotive Buttons pushbuttons, Ron Morris Performance crossmember, Spicer slip yoke
Thanks for posting this, something I’ll definitely look into.
This is my first time making one of these videos, so bear with me.
Oh wow! First video? Well done. Great camera shots too. Very clean install sir. Good Job. Will sub yuor channel. Thank you.
Hey there, did freshen up the trans, or install as is ?
If not, did you have them, add 2 clutch bands?
My research says, the V6 version, has two spacers, in place of two clutches, the OEM V6 didn't need..
Thanks, and good luck.. I plan on installing one myself, in a 65 Fastback...
I didn’t have anyone go through it. A local transmission shop wanted $1700; screw that. I only paid $300 for the transmission. It’s a 2002 model, and from what I understand, the 98-02 are the most desirable models.
Test drive video is up!
czcams.com/video/Fbo_FsYdhvU/video.htmlsi=bhQB61eaK_IIf4D2
What is your 4th gear overdrive gear ratio in that 4R70W trans? Do you know what rpm you are at when going 70mph or 80 mph with those 4.11 gears? How tall a tire are you running? Sorry for all the question but much appreciated if answered.
OD is 0.7. With a 28” tire, it ran 75 at 2500 rpm, and 82 at 3000 rpm with the converter locked. I’m now running a 26” tire, so it’s obviously running higher rpms at those speeds now.
Hi Dihlon! I run a built C-6 behind my 67 Mustang Gt with a 460 BBF. Off Hand, does anyone know if I could mate the 4R70W behind the 460? I also run 4:11 gears. Thanks for any feedback on this. Cheers from Motown/Dearborn.
It would not work with your current motor. The 4r70w has the SBF bell housing pattern.
What block plate and starter did you use, for your conversion? I just picked up, a "98" Mustang V6 4R70W. I confirmed the SBF bolt pattern, though the starter position is not the same as for, the old AOD V8 block plate used to check the bolt pattern.What year and model block plate and starter did use for you job? Thanks .
The block plate is CJ Pony Part# TSP12. The inspection plate is CJ Pony Part# INSP10. I used the same starter I was running in my C4. Don’t forget the 164 tooth flex plate.
Understood, thank you very much sir. Adding it to my 65 Fastback, lookin forward the same results you had!!!@@dihlonbecker3965
No problem. Good luck with your swap!
Are you running a 302 with that transmission?
351w