Brake Pad Replacement 2016 Hyundai Tucson Change Brake Pads Front and Rear

Brake Pads Replacement on a Hyundai Tucson. How to replace the brake pads on your Hyundai Tucson 2016, 2017, 2018, 2019 and put new Brake Pads Front and Rear DIY. I'll show you how to replace the brake pads and service your brakes on a Hyundai Tucson 2016 and newer yourself and save money. Should be the same procedure on all Hyundai models including Sonata, Elantra, Santa Fe, and Kia models, etc.
#Hyundai #HyundaiTucson #BrakePads #ModernDIYProjects
SUBSCRIBE: czcams.com/users/moderndiyproj...
BECOME A CHANNEL MEMBER: / @moderndiyprojects
Find me on CZcams: / @moderndiyprojects
Buy me a Coffee: www.buymeacoffee.com/ModernDIY
If you want to contact me: [e-mail]
Thanks for Watching.

[@Haffmatthew]

Great video! Appreciate the effort put into this concise and easy tutorial. Doing a coworkers brakes shortly with this car and wanted to know roughly what was in store. This is a very basic and easy to service setup, especially with the ease of returning the piston to fully open for the brake caliper. My VW is frustrating as it requires turning it to reset it whereas this is just a pressure system. Again, thanks!

[@allenfraser4857]

caliper pin lubrication is not general purpose grease. Petroleum products will damage the rubbers. Always use a specific brake lubricant on all brake components,

[@dentech4710]

Sounds like you take ideas for your videos from South Main Auto.

[@anthonymayi3082]

We need one from the same car but the brake roles, disc

[@inspirevlogger9709]

when fitting new pads or discs shouldnt i release bleeding valve? just to avoid getting any dust/rust into abs/break system and than causing problems with break valve jamming ect?

[@ModernDIYProjects]

You can do that, BUT I have found that your method can lead to air getting in to the system. The method I showed will not cause any problems because the brake system is a closed system. NO dust or debris will be pushed into the ABS system. You are just pushing the fluid back from where it came, and it is a closed system. So there is no harm to your system. The dust and dirt that is outside on the brake pads will stay outside and not go in your lines. If it does, then you have a leak and your brakes will already be failing.

[@roydoucet8841]

If the master cylinder cap is removed before pushing back the piston brake fluid will spill over so I leave it on now without consequence or am I missing something?

[@ModernDIYProjects]

If there is enough room in the master cylinder then you have no problem the way you are doing it. I would suggest to crack the top off and just leave it placed on top so it wont spill but you released any pressure that could build up inside the unit.

[@VIheavyequipment]

how have you liked the tucson has it been reliable any big repairs? im thinking of buying one have you got a lot of miles on it?

[@ModernDIYProjects]

It has been a trouble free vehicle in my opinion. The only thing that went bad was the water pump and that was replaced under warranty. Had a few recalls like most vehicles, all taken care of for free. It has over 100K now so it's out of warranty but so far no problems.

[@HandyMike101]

No break grease on guides, clips and back of pads??

[@ModernDIYProjects]

Not needed in my climate. In fact it may cause noise in my situation. If you live in a very wet, snowy, dusty or place where salt is used, then you need to use it there.

[@jsmith629]

New spokesperson for brake cleaner spray