69 Camaro Dashboard demo part 1

Published 29 Sept 2017.
This is the first of three videos on the demo, preparation / fitting, and install of the dash board. At first it didn't look that bad and I thought I was going to be able to fabricate something to repair the rusted area. This was not the case as you can see in the video. Looks like this dash board was replaced before , based on the bubble gum welding. :}
Thanks for watching and please comment.

[@gibsonexplorer8777]

Yours looks good! Compared to my rusted mess but fixed it and bought dash pannel good video your doing it right brother! Oh man commented before watching the end you didn't have to do all that but good job.

[@AlienRestoMod]

Thanks, sometimes I do over kill it. 😁👽

[@gibsonexplorer8777]

@@AlienRestoMod I have a 68 fierbird just had to drill the spot welds but would love to see your car when finished I bet it will be beautiful and done right not all jack legged like this wreck I bought I got it cheap but it was a wreck lol 5 years might be done in a few more never ending challenges...

[@Rarerat]

The holes in the dash are for the dash grab handle & plastic trim plate

[@AlienRestoMod]

Cool, thanks. Just didn't see holes in the old one and didn't want to send it back to AMD.

[@perrywe1]

Ceedell has a really good video on sectioning the dash. Too late since you took removed the entire dash.

[@AlienRestoMod]

I still look at it. Thanks.

[@travisblount637]

We are putting a new dash in our 69, how do we remove and install the vin plate with correct rivites

[@AlienRestoMod]

Picked up rivite set from harbor freight, tested it on something and then used it.

[@MrFireman164]

Good times

[@AlienRestoMod]

Sanding under the dash, inside firewall and all the little crannies sucks. Almost done should have primer paint on by Sunday.

[@MrFireman164]

Alien RestoMod yes it does , sounds good

[@gearhead1969]

You want to sell the old dash?

[@AlienRestoMod]

Sorry but it ended up in metal recycling center. Really didn't think it was worth anything other than scrap.

[@gearhead1969]

@@AlienRestoMod No problem. My 69 has some restomod amateur crap where the main dash used to be. That is the only section I need and I didn't want to replace the whole piece..

[@allenlackey116]

Lol would that financial adviser be the wifey

[@AlienRestoMod]

Oh yes and its all about how you pitch you idea. :}

[@fogtown3027]

Just buy a new Dynacorn body 😂