267whp 8th Gen Civic Si! Fully built & gutted
Vložit
- čas přidán 5. 09. 2024
- K20a2 head, drag cartel 4.5 cams, supertech valvetrain with steel retainers Ferrea 6000 valves
K24 block, k1 rods, wiseco 12.5:1 pistons, ported type s pump.
Skunk2 centre feed, skunk 2 header, skunk 2 3 inch exhaust, j37 throttle body, 3.5 inch intake
Skunk2 centre feed, skunk 2 header, skunk 2 3 inch exhaust, j37 throttle body, 3.5 inch intake
Id1000 injectors and a dw200 fuel pump
267whp 192tq
Tuned by chase_on_tuning !!
People that own a si knows that 5:50 sounds crazy cause short shifting and still being in power band spinning like that is insane in commenting a lot but I love this build
Good God this thing is spicy can't wait to see what chaseontuning can do to this beast next year wake it up even more 300hp n/a would be crazy
definitely retune, leaving a lot of power on the table.
That’s the plan dude. We didn’t touch timing 267 was on super conservative timing
This cars an absolute animal
god that idle is so good
I love this thing I have a tip for you too so you can save that transmission of yours with that much power too
Not hating but with the amount of stuff you’ve done to the engine I thought you would be running more horsepower than that . I’m running a K24a Rbb3 Makes 253hp 192tq
Skunk2intake manifold
Skunk2 3 inch exhaust
550cc injectors
74mm throttle body
Cheap air intake 3 inch
Skunk2 Alpha headers
Type s oil pump
Acuity short shifter
Carlos tuned on hondata
I thought he would be making more too
Car didn’t have timing touched at all, that 267 was strictly on vtc and fuel being straightened out. My flywheel ended up coming loose so obviously we stopped. Didn’t get back there to finish it yet.
@@clintonsmeenk1022that makes sense . You should throw some e85 at it in the future I bet it would be making really close to 300 .
How are you using a shifter box? What cables are you using and what else did you have to change ?
God bros this things move !!!!! 😈😍🤟
Love the song choice 😂🤣 party animals lol
that intake is cracking me up lol
Stock trans?
Yup
Holy sheeeit
💀 was that the cold air intake popping outside the bumper look like a stoggy
🔥🔥
any guesses on what it will do 60-130mph or 1/4mi. gotta get a dragy and do some runs
What’s your exhaust setup ?
skunk 2 header, skunk 2 3 inch exhaust, build list in description
Do you know your 60-130mph time ?? Just curious since I want to build my si as well
What throttle body are you running and is there any modification to get the center feed to work in a 8th gen si
Just need to cut water pump and get half rad and that should roughly be it
@@Hunchosburnouts is there a certain throttle body you have to use and what about the wire harness does it reach far enough
@@backyardracin used a j37 with an adapter. Also had to extend the throttle body plug