Stihl MS 311 Cylinder/Piston Rebuild, Part 2: Assembly and test!
Vložit
- čas přidán 31. 01. 2023
- Turns out Chainsaws are very sensitive to lean fuel mix ratios...
I only run ethanol free fuel in my small engines and that helps keep the funk out of the carb and fuel lines.
This video is the completion of the strip down, and reassembly. But will it run?
If successsful, this will essentially be a MS311 to MS391 conversion.
Link to the first video in this 2 part series: • Stihl MS 311 Cylinder/...
If you have any tips or tricks to add, drop a comment below!
#smallfarm #Smallenginerepair #homestead #homesteading #fixityourself #morepower
I love the cow mooing in the background!
Thanks for this! Same thing happened to me. Didn't shake the gas, scored the head and I concluded my saw was toast. I really appreciate the straightforward, no BS presentation.
The biggest piece of advice I can give when rebuilding chainsaws is make sure you oil the bearings on the bottom end and the wrist pin and also use a gasket maker designed for 2 stroke crank cases and is fuel resistant such as “Moto Seal” the reason that’s crucial is over time the fuel as it goes through the bottom end will eat away at the gasket and cause an air leak which will cause the saw to blow up over time. Overall you did and amazing job, hope it’s still running well for you
thanks for sharing, you answer a question I had about the engine size replacements vs oem.
Thanks for motivating me
Excellent video, clear and precise instructions, great job! I have a 311 that i need to rebuild, specs online all say 59cc but all rebuild kits seem to be 49cc, any idea why?
Mines in a box in a hundred pieces right now.
Where did you get that kit? I looked up that number and it says Hyway with nikasil plated cylinder. That the same thing? Thanks!
Well done. Has as much junk on it like vehs now a days to get to what trying to fix Always great feeling when done and fires right up. Is there a “break in “ procedure now ?
Where did you get your kit and how much did it cost?
Was that a big bore kit ? Alot of them say they will fit a bunch of models but dont list the 311 ? Can the stock cylender be bored that much and i can put a bigger piston in it ? Thank you.
Hey how’s it going I’m in the middle of tearing down my ms311 and I can’t seem to get the wrist pin out to pull the piston and change it what did you do for yours