💰Save That Money! With This Washer Spring Expansion Removal Tool! DIY 😎
Vložit
- čas přidán 1. 06. 2022
- In this video I show you that anyone without any experience can fix their own washer if there spring/wire pops out of the seal. I had this issue on an LG washer machine and couldn't pull apart the spring with any of my other tools. Found this on one Amazon and you can see in the video that I worked 🙌
Below is my Amazon Link!
amzn.to/3txVs8T
For Business Inquiries Email me at:
Wowmr.3@gmail.com
Don't forget to Like, Subscribe and leave a comment how your experience went. or if this tool didn't work on other brands 😊
This is next to impossible without this tool. Thank you for sharing.
No problem! Glad I could help 😊 Thanks for the comment!
Very goood video friend tool perfect from Spring
Best demonstration so far on CZcams. Thanks
Thank you! Glad it was helpful!
Start one side completely like you did, then do a 1/4 of the other side then grab a small hook tool and start at the 3 o’clock position while holding the other side and slide hook tool slowly from 3 o’clock to 6 o’clock and it should work. May take a couple tries to get it but not bad if u don’t have these pliers.
My clamp wasn’t clamped together when I received it wallaby’s do I do
Thanks! Used your link! It's a must-have tool and works!
Glad I could help and thank you :)
Good Job...Man!
😊thanks!!! With this tool it’s literally impossible to pop the wire back on!
No problem! Glad it worked!!
I'm replacing the door boot for my LG wm3488hw washer dryer. This particular model is a bit different than normal door Bruce. This model has two expansion rings. I can do the outer ring but, you need a different tool to remove & replace the inner ring. Please help me. I'm on a fixed income & LG won't come because I started this myself. TIA
Tried to install the spring with a screwdriver. Not a chance. Ordered this tool. Hopefully it is as easy as you make it look.
It should. I too tried it first with screwdrivers and vice-grips. I couldn't believe how strong that spring is! Thanks for the comment 👍
Does it make the job easier?
It makes it way easier!
I think my spring is too big so is there any other way I can get it in?
Thanks, I've been trying other ways 😡 in vain. Lol 👍🏽
No problem! I've tried them too 😅 Glad I could help!
is this tool required to get to the drain pump ? my drain pump is dead and i need to replace it
To be honest I'm unsure. I just quickly looked at this
www.searspartsdirect.com/diy/repair-guide/how-to-replace-the-drain-pump-on-a-front-load-washer
And they used the tool to remove the door boot. Hope that helps or someone can answer your question better
I used to use two flat blade screw drivers and hated ever minute of it
What is the name of that tool?!!
This is impossible to put back without the tool lol
Just rest your knee up against the seal next to the lock to stop it popping out. 2 second job.
Bought the tool but it didn’t work. Spring is already 5” I need a 9” tool lol
What kind of washer did you try it on?
outside screwdriver no need any special too!!! the inside spring must need special too!!!! i try my tool today, this too not work for inside spring, !!!