Superjet ADA Coupler for Jetski Midshaft
Vložit
- čas přidán 15. 08. 2024
- Probably not the most informative video I've done but it might help someone that is looking to add a little bit more speed with less rotating mass. This is the way I install the ada billet coupler on my jet skis. Thanks for watching!!!
🔻 BUILD PARTS! 🔻
2-stroke Oil: amzn.to/3yczo4T
Storage Case- amzn.to/3BskYi8
Yamalube Oil- amzn.to/2TOcnVK
Primer- amzn.to/3jTgr1G
Throttle Cable-amzn.to/3AC5g3j
Exhaust Gasket- amzn.to/3hJnUO5
Helmet- amzn.to/36oXdsY
61x Gasket kit- amzn.to/3hVt3my
TLD Grip- amzn.to/3xrYhrH
Carb Kit- amzn.to/3xu8vb5
Boot Retainers- amzn.to/36smJNG
1/4 Fuel line- amzn.to/3qUJwvf
3/8 Water Line- amzn.to/36oDute
Start Stop Switch- amzn.to/3hRrYMs
GoPro- amzn.to/3xw26fu
Mounts GoPro- amzn.to/3r0UZcz
MSD Enhancer-amzn.to/36pK0jE
Wire Wrap- amzn.to/3qXHudV
FTC DISCLAIMER: Coyote Chris is a participant in the Amazon Services LLC Associates Program, the eBay Partner Network, and other Affiliate Programs, an affiliate advertising program is designed to provide a means for sites to earn advertising fees by advertising and linking to the company's website.
"Due to factors beyond the control of Coyote Chris, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Coyote Chris assumes no liability for any property or personal damage that may arise from doing a repair on your vehicle after watching any of our videos. Due to factors beyond the control of Coyote Chris, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Again, any injury, damage or loss that may result from improper use of tools, equipment, or the information contained in this video or any of our videos is the sole responsibility of the user and not Coyote Chris." - Zábava
Nothing beats a big impact wrench and the coupler tool.
Yeah those are nice 😂 🤘🏼
How did you tighten on the new couplers?
If your asking about the driveshaft end I put vise-grips on the shaft and a pry bar on the coupler.
@@CoyoteChris is there a torque spec… or at least a concern about over tightening? (The big breaker bar is ready to work)
Also any need for grease, silicone, or anything else when re-installing the midshaft assembly?
@@kevinfisch1785 No just goodntight 😂. I’m sure there is but it would probably take specialty tools that I don’t have. Just get it good and tight. For the mid shaft assembly as far as the shaft it’s self you could put a little water resistant grease on it and grease the mid shaft assembly with 2 pumps. 🤘🏼🔥