Sur Ron Light Bee Battery Wiring Harness Upgrade 4AWG + QS10P-L VLOGs Part 5: Final Harness Install

In this video I go over my plan to upgrade the DC or battery wiring harness on my 2018 Sur Ron Light Bee MX. We have the controller, motor, and battery to push major power through the Light Bee but the stock battery harness is a huge bottleneck now.
In this video we finish building the controller battery harness by soldering the ignition wires to the new harness and put the finishing touches. Then we install the harness onto the controller and route it to the battery compartment.
Ingredients and tools:
QS10P-L 210A High Current Antispark Connector Male and Female QS10P-L Black (1Pair)
amzn.to/4c6WigS
4 Gauge Battery Cable Copper Wire, 3FT Red+3FT Black 4 AWG Welding Cable (I wound up returning these)
amzn.to/3z8ZQ3w
4 Gauge Pure Copper Ultra Flexible Welding & Battery Cable
www.windynation.com/products/...
SELTERM 10pcs 4 AWG-#10 Stud Tinned Copper Wire Lugs (A little too small)
amzn.to/3VyZvyD
SELTERM 10pcs 4 AWG-1/4 Stud Tinned Copper Wire Lugs (These might fit better)
amzn.to/3RFwKiD
TEMCo Hammer Lug Crimper Tool
amzn.to/3XxEW8s
Jokari 10270 Secura Cable Stripping Knife for All Standard Round Cables
amzn.to/4ch4Stx
KOTTO Helping Hands Soldering, Third Hand Soldering Tool PCB Holder Four Arms
amzn.to/45DvPFk
TOOLEAGUE 10 inches Cable Cutter
amzn.to/3RDqkR6
Dremel 2200-01 Versa Flame Multi-Function Butane Torch (I suggest using a micro torch for the thick stuff)
amzn.to/4bepCRd

[@angelozapp]

✝️🇦🇺💯♥️🙏