Pro Taper Twister Throttle Tube Installation
Vložit
- čas přidán 9. 07. 2024
- Watch this video and learn the proper procedure for installing a Pro Taper Twister Throttle Tube from JC Motors' very own Pro Taper representative.Find out why top-level pro teams are choosing Pro Taper to replace their stock throttle tubes. Then get yours today at JC Motors - Where Riders Get Deals!
www.jcmotors.com/throttle-tube... - Auta a dopravní prostředky
Thanks Mike!! Goona do one up for my XR650R. Hope to see you in Baja!!!!
I have this on my 05 crf 250 r and its a great. Such smooth action even over years of crashing. Compared to the stock one its a million times better. i remember breaking my stock one every time i crashed. and after getting this... never been a problem.
Can you use this with handguards? The acerbis pro bend?
Exactly what I was looking for.
hey guys! Do control guards fit through the end of this?> into the handlebars on the end i mean.
Will it connect to the cables of a klx140 ?
If I put that in my crf 150r, would it help the throttle play?
will it fit a 2003 honda cr250r
would you throttle assembly work on a motoriswd bicycle?
Is that the renthal twinwall handle bar? I want the pro taper throttle but don't know if it will fit the renthal twinwall.
Yes, it will fit just fine.
Twister Throttle Tubes are compatible with all Pro Taper handlebars and Renthal 7/8" handlebars with the standard bearing insert. It is a closed end throttle tube.
Any for pit bikes or r they the same fit
Would these fit on a 2012 YZ 250F? The bike comes stock with a set of Pro Taper bars so would it fit?
how much does it cost?
what happens if you need to install a handguard? Will you need to trim the end off or what do you do?
Buy an open end throttle tube.
do you happen to have anything like this for 1" bars and single cable?... its for a custom application
Unfortunately we don’t have anything like this for 1” bars.
JC Motors ok, thank you for your fast response...
Why not have the bike turn the other way? Be some much easy to see.
I used quick throt but my cable will always cut.... P9
From what I found, some of these bearings throttle tubes are not compatible with rental twin walls. Do you know for sure if you have any that are?
i just installed a throttle tube and i did everything right but the throttle isn't snapping back like its supposed to? and ideas?
Thanks for asking, we love to help our riders. Make sure you installed the cables correctly over the cam in the throttle housing. If its not in the groove correctly, it will bind.
If the problem still exists, check the route of the cable and make sure the gas tank is not pinching the housing of the cable against the frame somewhere. Lastly, there is a chance that you have a internally worn or damaged cable, in which case you would need to identify it and replace. Ride Safe.
Ooooohlaaaaa
He didn't even show nothing about the roller bearing didn't see what it look like didn't know how you put it in