Installing Borgeson power steering in 66 Mustang pt 2 of 2 (well, 3)
Vložit
- čas přidán 3. 06. 2017
- Part 2 of the Borgeson (USA) power steering unit installation into a 1966 Mustang, restomod. Includes Hub adapter and Nardi (Italy) steering wheel installation.
- Auta a dopravní prostředky
Thanks for the real life, regular guy, demonstration and video! I know that it would have been easier to just do the job, but you made a great how to for us regular guys.
instablaster
Wow very nice! I’m upgrading my 69 Mustang. May check out the Nardi wheel. Thanks for the video. Hope not as much cutting on my 69.
Hi, the steering wheel looks so good, would you mind tell us where can we get an exact same one, thank you!
well done
I had to grind some of the cast to make mine fit properly
I know it's been a few years, but do you recall the total you took off the column?
@23:20 you will hear I say I took off 6-9/16" total. Well since there is a bit of in-and-out adjustment on the column also, but not too much. I haven't had the column back in for 2 yrs but it will be put back in the next month's time... much done since then including replacing the firewall, engine/trans, rear end, floors, etc.
Me again, I would drill those set screws into the shaft a bit on the steering box side, you haven't lived until you have the shaft come out wile driving, ask me how I know.
Sounds crazy.... Thanks for the tip as I am near reinstalling the column after replacing floors, firewall, etc.