How To Install the SDI Motor Mount Plate on a Polaris RZR XP 1000
Vložit
- čas přidán 28. 07. 2024
- After aligning the clutches on your Polaris RZR, the SDI Motor Mount Plate keeps your transmission and engine shafts in line, reducing unnecessary wear on drive belts. In this video, Charles shows how to install the SDI Motor Mount Plate on a Polaris RZR XP 4 1000.
Shop Now | How To Install the SDI Motor Mount Plate
www.rockymountainatvmc.com/Sa...
Watch Next:
How To Align the CVT Clutches on Polaris RZR XP900 & XP1000
• How To Align the CVT C...
Check out www.rockymountainatvmc.com for all your parts, apparel, and accessories!
Click Here To Subscribe To Our Channel!
/ @rmatvmc
Follow Us On Social Media!
FACEBOOK: rmatvmc?utm_...
INSTAGRAM: rmatvmc?ut...
TWITTER: RMatvmc?... - Jak na to + styl
I agree it’s always good to start out w a clean hole
Awesome vid , I did install notice missing bolt, Can you help identify a bolt min 8:36 bolt #2 on transmission side thank you.
envias a mexico?saludos
Does the alignment tool and the plate fit turbo models?
Unfortunately, there isn't room between the metal housing and the transmission/motor to allow for a motorplate.
Why do they not make these plates for turbos but make the alignment tool??
Unfortunately, there isn't room between the metal housing and the transmission/motor to allow for a motorplate.
I have a question. I am having trouble getting the tap to start cutting the threads. I am using the 10-1.25 tap that is recommended. The drill bit that came with the kit does not fit in the enter hole. Does the hole need to be drilled out a little more? Thanks
I have the same problem with my 2015 XP1000... The hole is too small to get the tap started. I'm using a starting tap too as I have a whole set. (I still need to buy a bottoming tap for this plate but if I can't get a starting tap to work, I don't see the point). the Drill bit size for 10mm 1.25pitch thread is 11/32 and that size drill bit does not fit into the recessed hole (it's a hole within a hole). I'm a bit afraid to drill into the case unless that is what I am supposed to do.
I had the same problem. Using the 11/32 drill out the enter hole. Measure the bolt you will be using. Allow for the thickness of the plate you will be using. Mark the combined depth on the drill bit. Drill that depth and tap. That was the process I used. Hope this will help you.
@@user-qh1oi7bd5t ya I needed up slowly drilling out from 1/4th" to 11/32. I only have a tapered starting tap, but directions day to use a bottom tap and buy longer bolts than included... So I guess I gotta get another tap and longer bolts (the stock bolts would work with the length of threads I cut) but there must be a reason they want me to buy longer bolts..
Yes. You have to use 50mm bolts instead of the 40mm bolts that were provided with the kit. I think it is to compensate for the thickness of the aluminum plate.
Does this fit rzr 900 2011?
Sorry, these are only available for 2014 and newer XP 1000's.