Velikost videa: 1280 X 720853 X 480640 X 360
Zobrazit ovladače přehrávání
Automatické přehrávání
Přehrát
Never thought about knocking a hole in the oil filter. Great idea! Thanks
Great video. You made it look easy
Latex gloves are your friend unless your allergic to latex, also don't forget to always warm up your engine to normal operating temp and ensure the vehicle is level before performing your oil change.
Make a video on changing fuel filters porfavor!!
2:15 Nanny Goat.
Hello can you replace it diesel pump
Are all years the same to do
How much does the oils cost and the filter as well?
How many miles on the truck?
Hey how much oils do I need I total like how many litres ?
30 litros
Ok gracias Yo tengo 2009 internacional 4300 Entran 30 litros
How many gallons of oils to use for oil change
2.5 gal he said
@@TheNice4everything 2.5 gal? For a CDL truck? 🤦🏾♂️
30 quarts is more than 2.5 gal
30 quarts are a little more than 7 gallons
Adding oil to the filter is a bad idea. If any dirt or grime gets in it is unfiltered and goes to the bearings.
Would you suggest letting the filter fill itself and then add more oil after its full?
Never thought about knocking a hole in the oil filter. Great idea! Thanks
Great video. You made it look easy
Latex gloves are your friend unless your allergic to latex, also don't forget to always warm up your engine to normal operating temp and ensure the vehicle is level before performing your oil change.
Make a video on changing fuel filters porfavor!!
2:15 Nanny Goat.
Hello can you replace it diesel pump
Are all years the same to do
How much does the oils cost and the filter as well?
How many miles on the truck?
Hey how much oils do I need I total like how many litres ?
30 litros
Ok gracias
Yo tengo 2009 internacional 4300
Entran 30 litros
How many gallons of oils to use for oil change
2.5 gal he said
@@TheNice4everything 2.5 gal? For a CDL truck? 🤦🏾♂️
30 quarts is more than 2.5 gal
30 quarts are a little more than 7 gallons
Adding oil to the filter is a bad idea. If any dirt or grime gets in it is unfiltered and goes to the bearings.
Would you suggest letting the filter fill itself and then add more oil after its full?