Fitting heater to koi grow on tank! Energy use review and how to!

In this video I give step by step instructions and a how to install a cloverleaf 1kw pond heater into my grow on koi tank.
I also give my first impressions and a short review, including how much electricity it’s used to keep the tank at 12 degrees Celsius as I also put it on a tapo energy monitoring smart plug.
Learn with me as well as I show you how to solvent weld pond pipe as this was my first time doing it !! lol
Here are the links to my other videos I mention:
➡️ • Cloverleaf 1kw pond he... - unboxing the cloverleaf heater
➡️ • Insulating and claddin... - insulating the IBC tank
A couple of shout-outs too!
‪@edenkoipond‬
Thanks for your recent video where you put one of these heaters on your grown on tank and showing me how to do all this in the first place!
‪@AKoiEnthusiast‬
Thanks for your recent video where you showed the power usage of your setup! It made me realise it wouldn’t bankrupt me on the electric usage, and also, recommending the smart plug, that was a great shout!
Thanks for tuning in and please ask me any questions in the comments! 🐟 🐠
Current set-up:
IBC tank
* Evolution Aqua 10,000 lph Varipump
* AllPondSolutions pressure filter PFC-5000
* 11w UV
* Oase and Hoselock flexihose
* Cloverleaf 1kw pond heater
* Amazon float switch
* Boyu SES-40 airpump with 5” air stone
* DIY aerated bottom drain
* DIY internal moving bed bio chamber filter
* EA K1 and K1+ biological filter media
* Three stage dechlorinator on fresh water feed
Current Fish
* Momotaro Kohaju tosai (Koi Water Barn)
* Saki Karashigoitosai (Koi Water Barn)
Consumables
* Food: Medikoi Junior, Staple with colour enhancer
* EA Pure plus filter start gel
#koi #koipond #koicarp #pond #filter #diy #diypond #koifish #fishpond #evolutionaqua #allpondsolutions #water #productreview #unboxing #howto #pressurefilter

[@edenkoipond]

Nice update buddy. Hosetails drive me nuts! Good bit of kit the little cloverleaf heaters. Chuffed to bits with mine. Have a great Easter 🐣

[@chazkoi]

The annoying thing with the hosetails is that a slight change to the design would make them SO much better lol?! Hope you and the famo have a great Easter too!

[@westbromkoi]

Nightmare when first using solvent weld, I still go over the joints with CT1 after they've dried to make double sure 😂

[@chazkoi]

Totally agree ! 😂 hopefully next time I’ll be a bit neater lol

[@keepingitkoi]

Nice one chaz great video really enjoyed it 👍
Just be careful giving advice when doing electrics 😊👍

[@chazkoi]

Thanks for the feedback, glad you enjoyed it mate 😀👍🏻