Ford FOCUS Transmission SHUDDER and Engine LEAN Condition! | Dual Clutch Diagnosis
Vložit
- čas přidán 29. 06. 2023
- Clutch/Fork replacement with NO SPECIAL TOOLS!
• Ford Focus Dual Clutch...
Input shaft seal replacement:
• Ford Focus/Fiesta Dual...
How to tighten clutch nuts, step by step:
• How to Tighten Ford Fo...
How to make your own clutch handle for pulling/installing:
• Make Your Own Clutch P...
How to remove the transmission at home, in the driveway:
• Ford Focus Transmissio...
Transmission reinstallation at home:
• Transmission Reinstall...
This is my playlist, with 50+ Diagnosis assistance videos for the DPS6:
• Ford Focus DPS6 Transm...
From a dead stop accelerate quickly, foot atleast half way down on the gas or full throttle, do this a few times, the computer will relearn your driving habits and will engage the cluch harder eliminating or atleast reducing the shudder, you may have to do this every once in a while, hope this helps
So if 2 people drive the same car would that just confuse the computer?
10:00 you’re not weird, I enjoy working on my cars too!! I own a fiesta ST! I’ve owned a 08’ and 10’ focus in the past and just bought a 2015 focus flex fuel! Thank you again for making all of these videos
You're welcome! That Fiesta ST sounds like a lot of fun. I don't think I've ever driven one. Glad to help.
i have a 2012 ford focus that shudders and jerks from 1st to 2nd. I'm a working student don't have time or funds to replace clutch.
what i did is force a whole bunch of grease into the actuator holes... lol yea the grease actually gets in if you press down with the actuator. white lithium spray grease works too. seemed to have helped the shudders but it does shake around in hot climates or stop n go traffic...
ahh i just keep resetting it every once a while... never left me stranded in 6 months so time will tell i guess
This was very informative. Thank you.
You're welcome! Thanks for watching
How do you know if your car has a warranty 🤔
@@emisaelolmeda You can call your dealer service department and ask - have your vin and odometer reading
I had this issue after getting the recall done. The dealer didn't change the purge valve because they said the codes weren't there. I got the codes checked at a parts place. P1450 was definitely there.
Sorry to hear about that. If they can't help you, Rockauto has a WVE brand for $30. Should be able to find an OEM for $50 or 60
Thanks you
Very glad to have run across you and this video! So many conflicting reports and opinions out there about the shuttering. Is it at all common or normal? I have a very tiny bit at acceleration from a stop sign then nothing else. Thank you for any advice on this. 2016 ford focus se 88,000 miles
Glad to help! It's such a common issue on these I'd say it's normal. Drive it like you stole it on occasion and it'll mitigate the clutch shudder. I've got a playlist of other focus transmission videos I made to help if you're curious!
@@BigBensCarsAndCycles I appreciate very much the advice ! How do I know when it does become an issue ? And do you know what the fix is ?
Hi my auto matic 2014 ford focus get jerkie when changing gear on high way speed but when driving slow its smooth changing, any suggestions?
are there any codes or lights coming on?
I have a 2014 Ford Focus SE and I have the same Codes - P0420, P1450! There was a recall on these but ford won’t do it no more!!! The P0456 Is probably the gas cap!
Thanks for watching. I would change the purge valve before you replace your cat. Good luck!
These don't have gas caps
Hello, I have a 2018 Ford Fiesta diesel stick shift six speed. It drives fine for about 30 to 45 minutes then after that I get a shudder when pulling away in first gear, it’s driving me crazy any ideas what it could be please🙏🏻
Sounds like a cool car to drive. Wish we had that in the states. Sounds like you have some clutch chatter going on, and may want to replace the clutch, flywheel and slave cylinder
i have a 2013 ford focus and it runs perfectly fine. until i’ve been driving it for about 30 minutes and then it shutters really bad when i stop and take off and get around 30 mph. i’ve taken it to the dealership and they say it isn’t throwing any codes and they can’t duplicate the problem when driving it. i literally don’t know what else to do to fix it. my car finally threw a code and they replaced the o2 sensor but that wasn’t the issue for the problem. please help. 😢
That seems like a clutch shudder concern in your transmission. If that's the problem, it's a $3000 repair. When it's shuddering, you can try accelerating hard several times to scrub the clutch, which can mitigate symptoms for a period of time
Where is a good place to get a tcm from? Where do i take it to get programmed?
The ford dealer can do both
experienced my first ever hurricane @9:01
I completely forgot to add a headphone warning there. I hope your ears are okay! Are they? :/
@@BigBensCarsAndCycles im good haha! made me laugh xD. thank you for these videos btw, learning alot about the things i have to get done on my 2018 se
@@lurk_e you're welcome! I'm new at videos lol and it looks like I'd have to reupload it for that. Shame theres no feature to add info balloons! Thanks for watching
Are these transmissions really that bad? I just bought a 2012 focus with only 100,000kms for $5000AUD with timing belt recently done.
If you've got the updated design tcm and new clutch & forks they aren't too bad. Just quirky and they shudder
@@BigBensCarsAndCycles Thanks for the help, just saw your video on if the dsp6 can be reliable! All I hear is bad things about the transmission and to stay away from it, but so far it seems okay I haven't experienced anything too weird with it yet.
Where are you located? I want to bring u my focus to fix it.
Central va
I have a 2015 Ford Focus. The transmission shutter is a electronic clutch issue with it. It tells us that we don't have to worry about AI. The computer doesn't know how to engage the clutches. Ford has done several software upgrades, but it does not fix the transmission shutter. I found that you just have to give it a little more throttle to force the computer to engage the clutches.
150k on the plugs, it is time for a replacement.
For sure, and a dry clutch may not have been the best idea
Please see my comment above about your issue
I sanded the 3 ground connection it light weight made it a lil better than before