Replace Ls1 Harmonic Balancer and Pin the Crankshaft C5 Corvette
Vložit
- čas přidán 3. 08. 2023
- C5 Corvette ls1 5.7l v8 repair with OEM Harmonic Balancer and installing 2 pins in the front of crankshaft and a new ARP crankshaft bolt torque to 250 ft lbs. Thanks for tuning in!
- Auta a dopravní prostředky
Good video, thanks!
Which harmonic balancer is that? Powerbond
which pinning kit is this. If the drill bit was supplied was it a tight fit to go through the appliance before the drill got to the balancer and crank?
yes bit was supplied! You can get away with one pin and no it comes with a guide and you only drill into crank about a inch Hope this helps ill look at pin kit today and get you part number
That's the Massive Speed pinning kit. I got it off their website but they have it on eBay and Amazon too.
I noticed when I set my ATI balancer it looks like it doesn't sit flush. looking at your pics, looks like it isn't flush either. is that correct?
Did you put one pin? I Did two pins if you haven’t put it back together yet . I’d go deeper with drill bit ! It’s hard to see the tape mark..
I havnt drilled at all yet, all I have done is seat the balancer and torqued it down to make sure it was set. Just thought it was odd that it didnt sit flush. I am going to double pin.@@FOSTERSFARMGARAGETV
@@itskamel yeah double pinning it gives you that extra piece of mind! I used my impact for a final torque down and no problems whatsoever engine runs great! Good luck on your repair!
How much would this job cost?
$250 with new belt and seal