How to Install Blower Motor Resistor 07-14 Chevy Suburban
Vložit
- čas přidán 2. 08. 2017
- For More Info visit us at: 1aau.to/h/KG/
1A Auto shows you how to repair, install, fix, change or replace a bad or broken blower motor fan speed resistor. This video is applicable to the 09 Chevy Suburban
This process should be similar on the following vehicles:
2007 Chevrolet Suburban 1500
2008 Chevrolet Suburban 1500
2009 Chevrolet Suburban 1500
2010 Chevrolet Suburban 1500
2011 Chevrolet Suburban 1500
2012 Chevrolet Suburban 1500
2013 Chevrolet Suburban 1500
2014 Chevrolet Suburban 1500
🔧 List of tools used:
• 7mm Socket 1aau.to/otE/1AXAA00017
• 7/32 Inch Socket 1aau.to/ow/1AXAA00018
• Ratchet 1aau.to/ozb/1AXAA00016
• Socket Extensions 1aau.to/ow9/1AXAA00015
Subscribe: / @1aauto
Check out our playlist:
Chevy Suburban 2007-2014 10th Gen: • Chevy Suburban 2007-20...
Chevy Auto Repair Videos: • Chevy Auto Repair Videos
For More Info visit us at 1aau.to/h/KG/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video. - Auta a dopravní prostředky
√ *Watch the Video*
√ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto
√ *Do it Yourself*
√ *Save Money*
My same problem was the connector going into the blower motor. The pin was burned to a dark grey on the blower side connector on the back of the blower motor. Replaced jumper wire from resistor module to blower motor. Been working without a problem for over a month. Good thing to, cause we are having a heat wave here in California. Good Luck hope this helps someone.
Thank you for this! No nonsense just an easy fix!👏🏻👏🏻👏🏻
+Kimberly Miller Thanks for checking us out. 1aauto.com
Thanks! My 4yr old and I got the job done quickly!
Thanks for answering 👍🏼
Well THAT was a 10 minute job.
Thanks 1AAuto!!!
Excellent job 👏 👍🏽
exactly the same setup for the 2008 2500HD ... from start to finish it took 6 minutes ... hardest part was trying to get the %^%$ holes on the sound cover to line back up -- terrible design .... suggest that once you get to the resistor test the new one by unplugging the old wires to see if it in fact your resistor problem and not a fan or wiring harness issue ...
Where is the blower motor resistor located on a 2014 GMC Sierra SLE 1500?
I have a 2010 Tahoe and after about an hour driving, the air vents become blocked and don't blow air as much as in the beginning?
2 times since ownership my blower in front stopped working but rear still works. I disconnected harness both times and sprayed with MAF cleaner on both ends. Everything works afterwards. Suggest trying this before replacing to buy yourself some time but I think resistor is around $30 and probably worth just replacing.
+Chukwuemeka Onyema Both options will work and that is a great tip if you don't want to replace any parts just yet.
I'm going to he trying that lol
Its the plug to blow motor it gets loose i tapped it to resistor cables and has worked fine now
ki9
Thanks for the video the fan only comes on after tapping the black cover would that be the resister or the fan motor? Thanks
Fan
2013 tahoe lt
My middle row and back seat get no airflow but the feet theres air..i opened the rear and theres no blend door actuator just a resister ? Could that be my problem ? I hear the air turn on hot and cold..just doesnt go up to top vents. But i open rear panel and theres no blend door actuator just a resister? Btw 2013 tahoe lt ???
The one u replace in video is the one i believe for passenger..driver side is right on top of gas pedal 2 the right..
What about the other kind with the integrated blower????
It's easy to install, but how do you diagnose the problem, i had to take mine to auto electric shop, because none of the videos on CZcams helped me, and i didn't wanna spent on parts that i didn't need.
I need help with the deal that has the purple and black wires leading to it cn it be removed
Will this cause the front not to blow only the back?
1A Auto what were the symptoms of this vehicle that led you to replace the blower motor resistor???
+Chinn Boi Thanks for checking us out! The typical issue you will face with a bad resistor is only having the fan speed work on one or two speeds rather than all 5.
Mine works 100% of the time on high, but is intermittent on all other speeds. Is this consistent with resistor failure?
my fan would come on after i removed the keys from the ignition. I came outside one day and heard my fan blowing...i knew something was wrong
1AAuto question 09 Silverado white smoke coming out of the pipe not all the time just when I started and after a few minutes is gone.. no overheating yet but do you think the head gasket is going bad?
+Jose Marquez Thank you for checking us out. This is usually an indicator of the engine burning coolant, so we recommend having it checked as soon as possible. 1aauto.com
Do you disconnect the battery
Hello Can someone provide the part number for the Blower Motor Resistor for a 2008 chevy Suburban 1500
What if my a/c doesn't blow at all? I can change settings and everything but no air comes out, this happens before and it just started working again then went out again
Mine did that too - replaced this part and now it works great. Check fuses too just in case.
Its the plug to blow motor
This might be your problem. Or blower.
What year model is that truck!!!!!
Thanks
Is this the same procedure on a 2008 Chevrolet Avalanche
+Larry H. We currently do not have an auto repair video that covers this particular repair. We will keep this request in mind in the event that we need to make this repair in the future. 1aauto.com
1A Auto Parts followed your tools and installed the part in my 2008 Chevrolet Avalanche in less than 5 min... Thanks again for your help 👍
I had a new resistor installed, since then, something is draining my auto battery. It happens about once a week, not the battery. Does anyone have any ideas? 2002 Chevy suburban.
how do u know if resistor is bad
The Real Cody Bersick blower motor only works on high speed setting or one speed
What is the name of the first plug you disconnected from the resistor ? The one with Red / Black and Purple color
Its the blower motor wiring harness part # 22957044
My blower motor will not turn off. When i turn it off when put the new one n
Does anyone happen to know the location of the resistor in a 2016 suburban? I can’t find anything online, and it’s not in the same spot as this video.
Same issue but with 2016 Yukon, can't find anything anywhere on how to change it. Even posted that in the forum for TahoeYukon, no replies.
Same
On my 2010 I have to put it in full blaster it wont blow air. Is this the resistor problem?
+PABLO ESCOBAR In this case where it works on one setting then it is possible that the resistor is bad. If it was a bad motor then none of the settings would work. Hope this helps!
Can you do a replace a starter video for a 04 nissan sentra?
+UtePride8 Thank you for checking us out. We will keep this in mind for future uploading! 1aauto.com
1A Auto Parts thank you! And maybe fuel pump, filter, all that fun jazz ;) I love your videos and come to you guys first for every vehicle question!!
My front blower on my 13 denall wont blow at all. Would it be resistor or blower motor?
+Acres ninety Thanks for watching! The resistor is what controls the blower, so either the motor is dead or the resistor has failed. It could also be another issue, but we are unable to diagnose it for you.
is there a video on how to replace connector?
+Sifuentes_rogelio Great question! Check out our library for more videos here: 1aau.to/m/video-library-c
Hello I have an 07 Tahoe and my blower motor doesn’t always come on only when I bang it or hit a bump or something could this be result of a faulty resister???
+Outlaw 203 It could be a faulty resistor, but it could be a multitude of things. 1aauto.com
I have the same exact issue- did you find out what it was?
@@peterarvanitis8149 do you find aut?
Exact same problem...found to be a loose connection on the blower motor pigtail to the blower control module...it has gotten hot and partially melted. As someone else said, it could be a multitude of problems...start troubleshooting.
My 2012 is doing that exact thing also. It will not come on until I hit a bump
On a 2012 Silverado that's not the way the blower resistor comes out it's totally different
+Rick Branstetter This video is applicable to the 09 Chevy Suburban
I understand that it says on the video '07 to 14 not all of them are the same my 2012 is completely different it would be nice if you could put a video out for people on the2012 Silverado
Thank you
How do I know if it’s bad ??
+Joe De La Rosa If the blower motor is bad, it could be causing weak airflow, unusual noises, overheating, or odor.
It’s a module not a resistor.
Man this guy is trying to charge me $100 to replace my blower in my truck.
When you don’t know the difference between a screw and a bolt
Engineer's Tip: A fastener can be labeled as a bolt or a screw, depending on its application. A bolt is intended to go through two mating surfaces and captured by a nut. A screw is defined by being installed in a threaded hole, whether or not it creates its own mating threads.