TRX-4 Pro Scale light Kit Install
Vložit
- čas přidán 30. 03. 2022
- Traxxas TRX-4 79 Ford Bronco pro light kit installation.
This Pro Scale light kit allows you advanced lighting control with pre installed light kit, like signals, flashers, high beam low beam, brake lights, reverse lights and the ability to hookup extra lighting like lightbars. - Zábava
i’m rocking the orange body. sweet ride brotha
Got quite aggravated with that one set of wires. Running them backwards….genius.
I followed your video and my break lights and turn signals don't work
Good stuff. I'm building an rs200 on a 4tec chasis and I'm using this for all the lights. Can you tell me how it works front headlights independently off of just the H location when B for the rear has 2 spots clearly one for left and one for right
I have a second body.. how do i hook that up the say way?
I have the same bronco.... no lights yet. How many lights can you run . I have after market bumpers with lights and 4 on the roof rack. Total of 20 lights will this system do that ?
Also I have a sound box can I tie that in withe system ?
The module has 12 spots distribution block also runs the typical stock lights and of course being Traxxas you will need the Traxxas plug or Traxxas light kits. My sound box runs off power from the esc.
Nice video
Can you tell me where i need to put the roof light connector ?
And wich buttons to activate on the app ?
I can not get the roof light to work
I plugged my bar light and rock lights together but if it’s just a bar light run it over to the distribution block on the body and plug into port M this will give you control over high low.
In the app - dashboard-lights-aux light low on/off-aux light high is high beam low beam. Hope that helps
@@rc9119 ok thanks then i have the wrong roof light it does not light up. Wich one do you have ?
The trx number ?
I know it’s been awhile, but do you have a part number on that cable you used for the light bar and rock lights to connect them together? Or did you make it? Thanks.
@@MrTrimble2010
I did make some stuff to make it work it's in one of my trx ford bronco videos
do you need to install the maxx cable and rx cable together? i seen another video the guy did not install the rx cable.. i was hoping to get a clear answer.
The instructions say one or the other, not both.
Can you run this light kit with an aftermarket esc and receiver?
It’s Traxxas specific BUT with a little work I’m sure you could run it on anything.
is there brake lights? I just put one in brake lights done work just blinkers and parking lights
Ya you should have brake lights … single push forward from neutral
@@rc9119 I figured it out. No brake light in crawl mode. Any of the other modes takes a double tap for reverse. Brake lights work on the first tap. Thanks for your reply.
My lights won’t connect to app any advice
Did you connect the MAXX cable and you need Link module