US GEAR Strange Engineering Ford 9 Inch Ring and Pinion Installation

This video highlights how to install a US Gear Ford 9" ring and pinion gear set on a Strange Engineering rear end. The installation goes through each step of the process and is also applicable to Ford 9.5" and Ford 10" gears.

[@stanbci]

How long does it take to replace the gear and piñon my Jeep broke into on the 1st pass of our new 9” setup? Sounds crazy but it happened. Just want to know turn around time so I can drive my WK1 SRT Jeep Grand Cherokee again? We tried a 3.07 but are switching back to 3.73. Highly unusual to break I imagine

[@Guiohms.m50]

2:16 where can we get this tool in the vise ?

[@oscaracme]

CLICK BAIT.....this isn't an installation video....unless showing how bolts are tightened qualifies as "installation"

[@FastKiwiBoss]

Emailed there website, never get a reply, very poor PR

[@kurtthomas2157]

So nothing mentioned about looking at number scribed on pinion and using that information about setting pinion depth? Nothing shown about adding 1/8 inch spacer before putting bearing on? How to set bearing preload on pinion adding and removing shims, and using dial indicator? Why even bother with a video like this if you can't do it right? I buy all my stuff from Strange, but I do hate poor videos.

[@daleolson3506]

Backround music sucks,junked video