Beginners guide to Dremel Collets
Vložit
- čas přidán 21. 07. 2024
- Check out the Dremel multichuck video here • Multi Chuck Dremel Rev...
Dremel 4485 Quick Change Rotary Tool Collet Nut Set
amzn.to/3DVgfYI
Dremel Multi chuck
amzn.to/47sooRU
KUTZALL BURRS AND DISCS 5% Discount Use the code (Case sensitive)- MATTCARVES website: kutzall.com?aff=70
Disclaimer: Some of these links for purchasing are affiliate links where I'll earn a small commission if you make a purchase at no additional cost to you.
This video is based on my own experience and opinions - Zábava
Thanks so much
No problem 😊
Our brand new dremel 3000 kit did not come with Collet AND none of the shafts fit thru the hole on the collet nut.
What the heck?
Guess we are going back to Ace Hdwe.
Okay. Collet jammed up into collet nut so with it now loosened shank fits.
Glad I took another look at it.
Got it, rings for each 16th of an inch, not how to identify the size of the shaft of the burrs?
Thanks for the link Matt i need new collets. 👍👍👍
Rings are good info to know, thanks !
Matt, thanks ❤ 😊
I want to know the diameter of the collet to fit into the Dremel. I think it’s 4.3 mm, but not sure. Do you know? ( in mm please)
Yes it's 4.3 mm just measured it.
Our brand new dremel 3000 kit did not come with Collet AND none of the shafts fit thru the hole on the collet nut.
What the heck?
Guess we are going back to Ace Hdwe.
Found Collet, it was jammed up into collet nut so tight no tool shank would fit. Once I got it unjammed all was good.
(Wife was “helping”, so that’s my excuse…..)
Good to hear you got it sorted 👍
@@MattCarves
I looked at it BY MYSELF…
Are the different collet sizes for different sized shafts?
Yes that's correct. 1/8 is the most common burr shaft.
@@MattCarves so how do we know what the shaft sizes are on all the accessories bits?
@Barnaby_bo when you buy them it should say or measure them
@@MattCarves so it will say on the packaging?