How to Replace A Tumble Dryer Control Board (Hoover)
Vložit
- čas přidán 9. 07. 2024
- For all your tumble dryer PCB module spare parts go to:
www.espares.co.uk/search/pt19...
If your dryer is not working correctly and you have identified a faulty control board this video shows how to replace it.
Want to skip straight to the information you need? Here's what we talk about in each part of our video:
0:00 Introducing the video
0:26 How to remove the top panel
0:51 How to remove the control panel
1:07 How to remove the old PCB
1:58 How to fit the new PCB
2:47 Putting the tumble dryer back together
Thanks for watching! - Jak na to + styl
Hi I am trying to remove the plugs from the sockets at the end of the board. The ones with spade connectors. I can't work out if there is a clip or whether they just pull out. I'm worried that I will break the pcb if I pull too hard. Please can you tell me how to unplug them. Looks like you just pull them hard. Is that right? Thanks
I've got this exact model, would replacing this solve a problem with the lint filter light always coming on, even when the lint collector & heat exchanger below have been thoroughly cleaned?
Thanks a lot .
Hi JeanMarck .Lefebvre, you are welcome.
I have a Hoover Dynamic Next Heat Pump Tumble Dryer. It stopped working, so I had the run capacitor replaced. Which started the drum turning again. Although, since having that done. It only spins for 10 mins, then a long pause, then starts again. I have been told it is a reverse timer fault. Now would that be due to a bad connection (connector) or a pcb fault? Everything else seems to work fine heat, selector, drainage. Just the rotation seems to be a problem.
Hi Soulspinner, it does suggest the PCB is not reversing correctly, check the connections to the board and look for any signs of damage to the board.
@@eSpares Thanks for the prompt reply. I will have a look at the connections. If a new PCB is required, do you supply them?
Model no. DNH D913A2C - 80.
Hi i have followed your video and have found that a part has come off the board. It seems to be part where the start button needs to press on to start the machine. Do i need a new board or can this be solider back into place thanks
Hi baby deedee, if the board is damaged it can be difficult to repair and with limited success so you may need to change the board.
It was working a minute ago and then I went to put a new load in and the light won't even work, I've checked the fuse's in the machine and the wall socket and I'm confused, could you help me please
Hi Emilya, you will need a multimeter to test the circuit from the plug to the board, this will determine if you have a circuit and what has failed.
I have an E15 code how many pcbs are on the dryer ?
Hi Derek, it would depend on your model what board and how many, it would normally only be one main board.
@@eSpares ok thanks if it's just changing pcb that's great.