fault finding tumble dryer PCB
Vložit
- čas přidán 9. 04. 2021
- watch as i fix a PCB from a tumble dryer.
channel about electronics
/ @mathewlawrenceml
and my flying channel "rather be flying"
/ @ratherbeflying8212
also follow me on LBRY
lbry.tv/@RatherBeFlying
lbry.tv/@Matthew-Lawrence
If you wish to donate to the channel it would be amazing and completely unexpected.
BTC - 3A8oQxxR1di4GeWWEuJ4J42Zm7bWCRjwi8
ETH - 0xa499f8307F20478487B03a3a6945F5e0cc10e6cf
Hi I am trying to remove the plugs from the sockets at the end of the board. The ones with spade connectors. I can't work out if there is a clip or whether they just pull out. I'm worried that I will break the pcb if I pull too hard. Please can you tell me how to unplug them. thanks
If they are the same type. Then there is a little plastic clip that holds them together. You can use a small flat blade screwdriver to free the clip while pulling them out.
Good luck. And of course make sure the power is off first.
Hi, thanks. I have tried inserting a small screwdriver but no luck and can't make out where the clipp actually grips the plug. On other videos they appear to just yank the plugs out.@@mathewlawrenceml
How do I work out the volts on the inductor gives me zero readings want to change part no continuity