Video

My z4 has burbles stock but just very very slight ones. id like to make em louder ever so slightly keeping the nature of the sound but making em slightly more exciting

cool video and im a bit late but your monitor is shaking when you move your arm hjaha

Bmw e39 520i 2.2

Looking to turbocharge a 1.3 4efe engine from a ee101 Corolla. They made 4efte engines which made 135bhp but was looking to keep the original motor and be proud saying I turbod and built it myself

I have a question..a lot of people tell me that to make a burbles tune you need a down pipe. Is it true? If not do you damage your car?

Thanks

My warm up routine is just like yours

its a very fine line... I drive an B9.5 S5, all stock dont really want burble simply cause all the tunes i see with them cross that line

Thanks

You're a really great guy to listen to.

In winter, I start the car and let it warm up for 5 mins - I like the cabin to be toasty.

So, I have a 2012 genesis (Hyundai sedan 3.8) car. Can I make my love a death claw beast?.

2002 Audi a4 3.0 tdi quattro

Great Video buddy! Any recommendations for custom Porsche 911 tuners in the LA area? I use a Cobb Access Port.

I can’t even get my truck’s anti-theft to work with me

same as your warm up- and its a built EJ25- go easy until that temp gauge sits fat in the middle of the dial!

@Mzopyrus you just got another subscriber. Thanks. I want a JZ swap in an Audi A5 2014. Any advice? I'll appreciate it. Or what swap would be ideal?

Audi A3 👀🔥

What software would be better to use if I have an Audi S4? And what type of cable do I need?

Bro showed 4cyk and 6cyk little sputters show some hellcat or corvette or some big block v8 pops and bangs they will rip your ears out you feel v8s in your chest not even with the pops there’s not 1 v6 I’ve been near that will rip your eardrums like the sound of a v8. If your going to make a vid make a real vid enough with these little puny engines get the real gas guzzlers that dump loads of fuel 😂 and shoot 3 foot long flames. Something about the v8s that cause the loudest explosions

Car is Fdrx7. Do you keep twins or go single turbo?. Which turbo(s) would you choose based on your advice? Thanks, your video/content was phenomal!

One thing i recommend getting to start with is a dead blow hammer. Best hammer out there for not damaging stuff and won't bounce off of what your hitting.

My warm up routine is start and drive immediately no idle, in my petrol/gas motor i keep it below 30% of max rpm until coolant and oil are both up to temp and in my diesel i do the same but keep rpm below 45% if max rpm until all at temp.. both my vehicles are direct injection, petrol car is 2009 mazda 3 2.0 sport on 114000miles still running tight and smooth, diesel vehicle is a 2006 vw tuareg 5.0 v10 with 125000miles and also starst runs and drives like new... i change oil every 4000/6months on the mazda and every 6000/6mobths on the diesel. I run archoil fuel system cleaner in both vehicles every 1000miles and they both return at least the mpg and performance they did when new. I think the most important thing is keeping everything gentle until operating temperature and high frequency oil changes with high quality oil and high quality fuel or regular fuel system treatments

You failed to consider higher warmup RPM’s and the transmission clutch burnout over time.

Want to turbo my 1984 Honda 200 m trike as a project y’all think it’s possible

Could i tune my 2012 malibu to make this noise?

What sites do you use for dyeing a turbo

i want to buy this summer a BMW 320 E90 2009 and i want to put a burble tune because its cool

I wanna turbocharge my 2018 f150 5.0 V8

So basically they are wasting petrol?

A boring Toyota avensis T25 1.6 petrol 😂 the turbo would be worth more than the car

I'm gonna turbocharge my 2005 Buick allure CXL 🤣

Now, I just need to convert everything to SI units because I'm european

Earned a sub. Thanks for your simplistic explanations. I’m starting to build a g35 and know nothing really so CZcams is my friend lol.

Subscribed. It seems like there should be software to automatically optimize your tune.

It might just be my age, but most burble tunes just make the car sound completely broken (in my opinion at least). Doesn’t make sense to me. Great video though, easy to understand. 👌

Need a burbble on a fiat uno 2001

The advantage that I have is that the swap I want to do was already available as a factor option, so the car is prepared to accommodate that engine

How didn't I know about this channel 💯

The background music is shit

Bmw 440i xD factory burble is Nice

Really not that boring bossman, lots of good info here. I'm trying to turbo/supercharge my 1990 mazda 626 LX, if anyone has done it before or knows of better way to go about thinks please hit my dm.

Again..great info. Thankyou.

I have a problem. Its a 12.5l

GREAT INFO CHEERS

cool. time to LS swap my 2010 vw polo

What am I trying to turbocharge you ask? A fucking lawnmower for no fucking reason at all

Great video thank you I’m working on my 85 el Camino it’s my first project car

Thanks bro

I'd recommend knipex pliers wrench. Pricey but you cannot buy a more versatile set of pliers. Also, the 1/2 Milwaukee will remove crank bolts all day long. Along with anything else you can find