Velikost videa: 1280 X 720853 X 480640 X 360
Zobrazit ovladače přehrávání
Automatické přehrávání
Přehrát
That is definitely a close fit. My only concern would be for heat expansion causing it to foul.But, I doubt it would see enough heat for that to happen.
It has around .040 so it should be fine, I should have measured and trimmed though.
I use an oxy torch and heat the race while spinning the hub and the race will usually just fall off no pounding or chiseling needed.
Good tip, it would make it easy to do the "blind bearing" design hubs with no relief for a chisel to fit.
Do the wheels usually sit forward in the wheel well like that or is it the angle of the camera?
I think it's just a combination of camera angle, and the other corners of the car on jack stands.
That is definitely a close fit. My only concern would be for heat expansion causing it to foul.
But, I doubt it would see enough heat for that to happen.
It has around .040 so it should be fine, I should have measured and trimmed though.
I use an oxy torch and heat the race while spinning the hub and the race will usually just fall off no pounding or chiseling needed.
Good tip, it would make it easy to do the "blind bearing" design hubs with no relief for a chisel to fit.
Do the wheels usually sit forward in the wheel well like that or is it the angle of the camera?
I think it's just a combination of camera angle, and the other corners of the car on jack stands.