302 Cleveland into 393 Stroker Part 1

Mick from MS engines turning a 302 cleveland into a 393 stroker part 1.
If you would like to follow us on Facebook, please do so below :)
/ msenginereco. .

[@frankcastle5821]

Couldn’t believe it when I stumbled onto your youtube channel Mick!
My 351 XE GHIA now has only 2000k’s on it ..
Not bad for 20 years ago rebuild and it needed a double acid dip😂😂😂
Still runs great 👍

[@theinterestingchannel7966]

cant get enough of these videos a real workshop and a real tradesman would love some t shirts!

[@marko1025]

You have forgotten more than I know about engines . Love your work Mick . 👍🏻

[@nova467spanker]

MS Engine Reconditioning The rear seal is guaranteed to leak if you put them in the registers like that. You have to stagger them about a 1/4"

[@Selkirk69]

exactly right!

[@ProudMary53]

Another great and informative video, Mick. Love watching your videos.

[@bigal878]

Mick, I love your videos and love that stubby cooler.
Keep up the great videos. Cheers Al

[@jerrydefilippis4147]

Hi Mick
Always entertaining and educational, keep more videos coming because I keep watching, love the merchandise but the stubby holder need a well deserved beer in it , keep up the awesome work cheers Jerry

[@danonoveh8114]

Great video mate👍🏻🤗

[@danonoveh8114]

I see your using a two piece seal with that new stroker crank any leak issues?🤔

[@leighsaunders3278]

Mick the magnificent, Never a dull moment in this factory. How's your back doing mate?
Have you sorted the flexible front end on your Orange beast next-door yet?
Oh Bullshit CZcams says you build them in 20 mins ( The beauty of television hey )
It's the behind the scenes wizardry that people don't see that costs all the moochacha...🤙

[@leighsaunders3278]

@@MSEngines Mick you make it look easy, yes its the behind the scenes stuff that takes the time..🤙

[@russelblackwell6041]

the red block is a boat anchor

[@jeep-australia]

393 with 450hp, must be low compression ratio?

[@jessbrand5079]

Mini big block 👌

[@briggsfamily1303]

Good philosophy...may cost more ,but it’s Australian made.cheers

[@XDESP80]

What clearances did you run on the mains and big end bearings? ? 🤓

[@benni727]

what size cam are you running