Did you have any issues desoldering the switches? I have a vacuum desoldering station and it’s not pulling off the solder on the switch side of the board. I may have to clip off the legs then pull and clear out the holes. I don’t want to heat and lift the traces.
Thank you Mac! This was very helpful.
Hi! Can you tell me, what is the height of switch? 4.3 mm or 5 ? I want to replace mine. Thank you!
What are the sizes of the tactile switches 6mmx6mm x4?
Thanks for the video lesson! Is “the fix” still working?
Yes
@@macshock632 = thanks 👍🏼
Thanks for this. Which height of micro switch 6x6mm are used in this repair? Thanks!
I did not measure. Ordered from L6 Service Center with the reference number. Cost 0.3 the piece
@@macshock632 could you please measure it ? thanks a million!
@@sergejk i believe it’s 4.3
@@sergejk 4.3mm and 5mm have been said to work but the Line 6 replacement is 1.5 or 4.5mm total height.
Did you have any issues desoldering the switches? I have a vacuum desoldering station and it’s not pulling off the solder on the switch side of the board. I may have to clip off the legs then pull and clear out the holes. I don’t want to heat and lift the traces.
Yes, it was a bit tricky. I think we did the same on one leg.