Rotary Cutter Break Down and Demo! Land Pride RCR1860!
Vložit
- čas přidán 23. 08. 2024
- Chris discusses the ins and outs of rotary cutters and helps you understand what you need to know to get to work!
Content provided by Huckabones Equipment, Cobden Ontario Canada.
Find us online: www.huckabones.com
Contact us by e-mail: youtube@huckabonesonline.com
Call us: 1-613-646-2708
Content edited by Mainville Media:
/ mainvilleatvandoutdoors
#RotaryCutter #BrushHog #LandPride
I love your videos!
Would it be possible to make them with the tractor operation scenes without music (or even separate videos)? I love hearing the diesel engines and transmissions and implements make their sounds. It tides me over until I can own a Kubota of my own.
Also thank you for helping out the monarchs. I only have a little over three acres but I grow as much milkweed as I can so we can save them future generations. ❤️
Thanks for watching, I'll see what our editor can do
As for the monarchs we were able to raise 350+ this year, its a ton of fun to do with the kids
Ive been waiting on those R-14 tires since May!! Man i hope they come in soon!
My dealer was nice enough to loan me a set of R4's until they show up
You and me both!
Cutter especially, when turning always look forward and backwards at least until you get really good at knowing exactly where your empliment is going to be.
waiting for the m5 series videos like these :)
Just finished up a couple of videos, MX6000 overview, M6S overview & M6S in action with a BV5160 Baler
Don't dump the clutch and it won't do that. Or is this an electronic pto with a switch?
How tall is the sides on this landpride 5 ft cutter
Why do you guys leave that little booklet stuck on your pto drive shaft? lol
Do you think the LX2610 cab can handle that cutter? I'm sure the extra HP helps.
I have the B3200, and although it ran it, definitely had to have some weight in the front end loader.
Does that model Kubota use a PTO switch? I have a PTO clutch in my B3200 and start/stop the rotary cutter at idle. It's much smoother than what is demonstrated here.
That is correct, the LX models have electronic PTO switch so its bang on bang off. Older models are mechanical which you can feather on.
What bushings do I need for my qh15? RCR1860 and BB1260. Thanks. Some are pretty expensive ($35 ish), others are simple sleeves that only cost a couple bucks each. Cat 1 -> cat 2...then do I need another to go over the cat 2 to go to cat 3?
just the cheap sleeve bushings for a couple of bucks will do the trick, just need to go from 1-2 cat
So would a L3301 or 3902 be plenty of HP at the PTO to run that rotary cutter?
Yes, I run one on my L2501.
I as well run L2501 and the RCR1860. You would be surprised of the torque it generates
What model Kubota tractor are you using here?
LX3310
You did not have it adjusted correctly!