2016 VW Passat injen SP3077P Cold Air Intake Install
Vložit
- čas přidán 10. 08. 2021
- Installation of cold air intake on Volkswagen Passat R-Line 1.8 from start to finish in under 1 hour.
injen cold air intake model SP3077P
Purchased from ModdedEuros.com
Link: www.moddedeuros.com
This install will be the same or similar to the following models:
2014 - 2017 VW Jetta GLI 2.0L 4cyl. Turbo
2014 - 2017 VW Jetta 1.8L 4cyl. Turbo
2014 - 2017 VW Passat 1.8L 4cyl. Turbo - Auta a dopravní prostředky
Bro I’ve been trying to find modification videos and really anything on my 1
2016 tsi Passat and it’s fucking difficult I appreciate the fuck out of this video hell yea!!
You did a amazing job teaching how to install a cold air intake on a 2014 vw 👍👍👍
Glad it was helpful!
@@mxdaddy any issues with the intake? Did it cause a check engine light?
What did you do with the little hose that was on the front of the factory air box? Where does it go now?
Does your main pipe which is hooked up on turbo from back of the engine touching brake fluid reservoir,
I have a 2018 vw Passat Rline and my stock intake has a mass flow sensor on it and I want the AEM intake system, every video I’ve seen doesn’t show the mass flow sensor on the top like how it is on my car, Any advice? or if you’re car did have a mass flow sensor on the stock intake.
What’s the best way to get the coupler reducer onto the turbo. I think my install is not sitting right causing codes. I get mine onto the turbo and tighten it correctly. Once it’s on and I look at it another time the screw has moved around the coupler. I installed twice and can’t seem to get it to hold right. Thx!
What would this connector be that is connected to the filter tube?
Hey is it the same for a 2014 Passat 1.8L engine? Like the same steps to install it?
where did you put the maf ?
Sounds Like You Have A Timing Chain loose,(TICKING NOISE) is that true? That’s how my 14 VW PASSAT TSI ENGINE sound minus the intake noise.
Not loose. This engine sounds that way, only when you're under the hood.
I have a 2014 Volkswagen Passat with the same engine...will the same part work for me?
nevermind i just read the description hahaha thanks!
What did you do about the secondary induction line?
It fixes to the front pipe just to the passenger side of the block plate. At 12:33 you see it getting plugged into the pipe.
3:21 I’m copying the metal heat shield.
You can use any flat sheets pvc, plastic, metal, those big ac metal tubes just flatten one out you get the idea
will this fit on the 1.4L ?
I am not sure, I would contact Injen for complete applications.