Fitting A motorhome Clutch

DIY Clutch Replacement for Peugeot Boxer, Fiat Ducato motorhomes and Renault Master Camper Vans
Looking to tackle your own clutch replacement project? Start by degreasing the flywheel and removing the old bearing. Then, carefully install the new clutch kit, ensuring proper alignment with a clutch alignment tool. Don't forget to tighten the bolts evenly and use scissor jacks for lifting if needed. After installing the slave cylinder, test the clutch pedal for smooth operation. With these DIY automotive maintenance tips, you'll have your vehicle back on the road in no time! Explore my CZcams channel for more helpful tutorials on repair, and maintenance
Clutch Tool Here amzn.to/47dQcJ9
Holts Brake And Parts Cleaner Here amzn.to/46VrDAD
High Temp Rtv Here amzn.to/3MtNwyE
Blue thread lock Here amzn.to/3QBuEin
Wera Kraftform Maintenance Kit here : amzn.to/48I9yHJ
Dickies Men's Premium Insulated Duck Coverall here amzn.to/3uyyLEL
If you like my videos please consider hitting the subscribe button. It helps a lot
Email [e-mail]
“As an Amazon Associate and an eBay Partner, I may earn a small percentage from qualifying purchases at no cost to you.
Thank you so much

[@TheNarrowboatThatJamesBuilt]

Good work pal
Bet that beer tasted good

[@DoItWithPaulie]

hey mr.yes tasted good,that was a crappy job.how you doing mate?

[@colin5064]

You are a warrior, bet that beer tasted good after that strugle .

[@DoItWithPaulie]

Cheers Colin. i earned that beer i reckon lol

[@brrehalkjelsvik5396]

Merry Christmas!

[@DoItWithPaulie]

Thanks Borre.Wishing a very Happy christmas to you and your family

[@jimstelfox6120]

So the way used to get my beetle engine out which looks similar to your gearbox is, I took my wife’s best large wooden bread board put narrow blocks under it and screwed castors to them. Next job was the narrow blocks should be positioned far enough apart to get a trolley jack between, also having the height to get the jack lifting part in the middle. Next using a ratchet strap tie the gearbox to the bread board, get the boards castors onto a level surface ( drive, garage floor or plywood sheet ) and lift it up and slide it in.

[@DoItWithPaulie]

that sounds like a good idea. i really need to get a trolley jack.i did everything with those scissor jacks lol

[@johnmacdonald2243]

😊

[@patriciaj8226]

Bet you are glad that job is done
and dusted out of the way.
Well done 👍👍👍

[@DoItWithPaulie]

yes its a relief.and it works. thanks Patricia

[@merseadreamers]

Done a fantastic job with the refitting mate big up to ya

[@DoItWithPaulie]

cheers. im glad its back in..phew!!

[@Engineersoldinterstingstuff]

Great work, could you do an estimate on the time please..?

[@DoItWithPaulie]

hi. i would say around half a day to remove and about the same to refit. Cheers

[@Engineersoldinterstingstuff]

@@DoItWithPaulie Thanks!