Thanks, carnal! Your bonus tip of the tail light junction box was my problem. I pulled the plug, cleaned the terminals and the plug, and my tail lights magically started working again. I'm ordering the box from RockAuto (1/4 to 1/3 the price of the local auto stores) so I can have it in place if the box fails completely. ¡Órale!✊🏼
Great video helped me I tried the fuse you said it was my front passenger blinkers that would not flash but had power so I checked my fuse inside cab fuse 5-ctsy (15a). 2010 Silverado it also fixed my dome light too
Another easy check If this does not fix the issue. Unplug the lever lock connector for the door wiring harness that is in that same fuse box in the dash. See if the fuse stops blowing. It worked for me. Had a short in the door harness.
I have a 2016 silverado, my fuse box is complete different than this video. For this of you with these symptoms I’m going to post, check fuse for BCM (4,5,6&7). Symptom(s) 1. Turn signal not working 2. Interior dome lamp doesn’t come on when opening the door 3. Able to shift gears without pressing brake.
My 13 Silverado has the same problem, I switched the fuse like so in the video. But it still won’t work? Could it be a circuit or something wrong with the wiring?
If it's not the fuse then check the distribution panel in the rear of the truck where all the lights connect on one panel. Sometimes those get corroded. Just unplug the junctions, blow them out with some air and repug them back in. If that doesn't work then try the switch relay box located under the panel beneath the steering wheel. But before you do all that I would try testing it with a light meter or a tester and seeing where no power is going
The stock radio system made the flasher sound out of the front left speaker. As well as your other warning chimes: Lights on, key in ignition, back sensor. This interface works perfectly in my truck: PAC RP5GM31 Radiopro5 Interface for General Motors. Been running that interface for 8 years now. 2012 Silverado
Ya cheke eso y no funciona lo que puedo notar es que los focos no estan muy fuerte la luz los de atras los cambie is quiero a derecho para checar focos y no funciona parese que no llega mucha fuerza alos focos ya nose que hacer
Thanks, carnal! Your bonus tip of the tail light junction box was my problem. I pulled the plug, cleaned the terminals and the plug, and my tail lights magically started working again. I'm ordering the box from RockAuto (1/4 to 1/3 the price of the local auto stores) so I can have it in place if the box fails completely. ¡Órale!✊🏼
Great video helped me I tried the fuse you said it was my front passenger blinkers that would not flash but had power so I checked my fuse inside cab fuse 5-ctsy (15a). 2010 Silverado it also fixed my dome light too
Sweet!!!, Thanks for your feedback
Thank you very much I was chasing this problem on my own truck and with your video was able to straighten it out
My guy!!!!! THANK YOU!! I saved myself a trip to the shop thanks to you👍
Im subscribing!
You're welcome boss thanks for your feedback
@@nestorautorepair No prob! Dope truck btw!🤙🤙
Thanks
Awesome video. It worked right away as soon as I rePlaced the fuse.
You're welcome boss , thanks for your feedback
Man thanks to you I saved time but wasted money on things I didn’t need THANKS
Wow ok
My guy you saved me so much money. Thank you!
You're welcome boss , thanks for your feedback
Man this fixed my lights, thank you!!!!!!
You're welcome boss , thanks for your feedback
thanks very much you solved my problem and now all works great
Thanks for your feedback boss
BEST VIDEO!!!! THANKS MY GUY👍🏼🤙🏽✌🏽
Thanks boss for your feedback
Thank you for the troubleshooting!
Thanks! This was making me crazy!
You're welcome
Hey man! Question for you was your 3rd light working? I could not see it at the beginning of your video.
Thanks so much fixed my problem
Your welcome thanks for your feedback boss
Another easy check If this does not fix the issue. Unplug the lever lock connector for the door wiring harness that is in that same fuse box in the dash. See if the fuse stops blowing. It worked for me. Had a short in the door harness.
what do you think about the rear passenger flashing but the front passenger is not?
Thank you for sharing 👍
Thank you for your feedback
I have a issue where my running lights don’t work on my taillights but everything else does any suggestions
Okay so I have fuse #6 blowing but turn signals work. 3rd brake light doesn’t. Do you think this is related?
What fuse is that on the diagram (name)
I changed my module in the rear and nothing, checked fuses and they’re good, what could it be??
Bad wire or bad ground
Does that will work with suburban 2012 ?
Also thanks for your upload
Thanks
You're welcome
Al millon 👍💯
Gracias
Where did you get the housing? Fuse is not working, thank you for the video, much appreciated
Any auto parts , thanks for your feedback
Will that bonus fix work if both my front and back drivers side blinkers don’t work? Replaced fuse and still nothing
I will say yess sir ,,, make sure you add a ground wire first and see if the turn ON
What if it’s the right side ? Same sensor
Nicee
I have a 2016 silverado, my fuse box is complete different than this video. For this of you with these symptoms I’m going to post, check fuse for BCM (4,5,6&7).
Symptom(s)
1. Turn signal not working
2. Interior dome lamp doesn’t come on when opening the door
3. Able to shift gears without pressing brake.
Im having my left turn signal problem not working , all of those fixes are good what should I check next ?
@@josecarrera8923 im having that same problem.
My 13 Silverado has the same problem, I switched the fuse like so in the video. But it still won’t work? Could it be a circuit or something wrong with the wiring?
Try the box I show on the video
If it's not the fuse then check the distribution panel in the rear of the truck where all the lights connect on one panel. Sometimes those get corroded. Just unplug the junctions, blow them out with some air and repug them back in. If that doesn't work then try the switch relay box located under the panel beneath the steering wheel. But before you do all that I would try testing it with a light meter or a tester and seeing where no power is going
👍 thanks for sharing
@@nestorautorepair did the junction box part fix the problem? Same issue, fuse #6 is good
But why I don’t hear them in my truck it’s a 2008 Chevy Silverado
Why my truck when is flashing doesn’t sound like that. That happened after i replaced my radio
The stock radio system made the flasher sound out of the front left speaker. As well as your other warning chimes: Lights on, key in ignition, back sensor. This interface works perfectly in my truck: PAC RP5GM31 Radiopro5 Interface for General Motors. Been running that interface for 8 years now. 2012 Silverado
Ya cheke eso y no funciona lo que puedo notar es que los focos no estan muy fuerte la luz los de atras los cambie is quiero a derecho para checar focos y no funciona parese que no llega mucha fuerza alos focos ya nose que hacer
Hola puede ser un Tierra ,, trate de agregaroe Tierra a uno de Los bombillos aver que pasa
انت كفو اشكر امك زبطت معي 🤍👍🏼
What is its on the passenger side 🤔
Same fix
My 2007 chevy silverado has the same problem i put the new fuse and keep blowing the fuse
Then you have a short maybe be in the box I show you
Same issue, it just keeps blowing the new fuse I put in.
Did you find the issue Angel?
You are having a short somewhere
@@nestorautorepairwhat box??
Omg mannnn I just put new harness and control circuit board and everything in and it was a fuckin fuse
Wow you watch my video too late lol
@@nestorautorepair yeah I’d say lol