TOP SPEED 40 hp Johnson 16 FT Bass Tracker !!

Sdílet
Vložit
  • čas přidán 14. 10. 2023
  • First shake down rip on my restored 16ft Bass Tracker with a 40hp Johnson. After rebuilding the transom, epoxying the hull, painting the engine, and much more, it's finally, time to check out all my hard work on this 16ft Bass tracker. This will be the first time I have ever had it on the water! Top speed run is always priority, and the results shocked me!!
    Bass Tracker Restoration Series:
    • #1 P.O.S.💩 Pulled out ...
    @kentuckyyankee
    #topspeed #boat #fast
  • Auta a dopravní prostředky

Komentáře • 44

  • @chuckchin253
    @chuckchin253 Před 7 měsíci +3

    well worth the work....nice benny

    • @kentuckyyankee
      @kentuckyyankee  Před 7 měsíci

      Thanks! More videos in the future on this boat I'm sure.

  • @clifffawcett
    @clifffawcett Před 7 měsíci

    Look at that baby rip! Good job Benny!

    • @kentuckyyankee
      @kentuckyyankee  Před 7 měsíci +1

      Thanks! It did rip man! I was very happy, need to adjust the timing a little more.

  • @davidaldrich3488
    @davidaldrich3488 Před 7 měsíci +1

    just great diy//////back to the Datsun

  • @anthonyaviles8665
    @anthonyaviles8665 Před 6 měsíci

    These trackers boats with a small motor move really good 😊

  • @martinhancock5846
    @martinhancock5846 Před 7 měsíci

    You the man,without a doubt

  • @ronvore5269
    @ronvore5269 Před 7 měsíci

    Very nice, you did a great job.

  • @jaydee5156
    @jaydee5156 Před 16 dny

    I've always been a Mercury outboard, but I also had an '89 16' Tracker with that same Johnson outboard. That was a strong running little motor. Trimmed up, it would easily run 34 mph.

  • @Nrgpack
    @Nrgpack Před 7 měsíci

    Wow, that's a little over 26 knots and it sits great in the water too. Good job and thank you Benny!!!!

    • @kentuckyyankee
      @kentuckyyankee  Před 7 měsíci

      Thanks Tom, I was impressed with this little rig.

  • @boatgalhb1142
    @boatgalhb1142 Před 2 měsíci

    I would name her “Scooter!” Nice boat, I have a 32 Hatteras and sometimes miss the simple things I also have twin BIg block Chevys and get 1 gallon per mile per engine!! Sluuuurp!

  • @paulhenry8586
    @paulhenry8586 Před měsícem

    I have a 1983 bass tracker classic 16ft and originally had a 40 horse Yamaha and it ran about 34 mph . Since then I completely stripped the boat and replaced all the wood and foam and turned it into a tiller drive. So now the boat doesn't have the console or bench seat or back deck or original livewell and I bought a 40 hp tiller hopefully it hits high 30s

  • @ashtonray5230
    @ashtonray5230 Před 7 měsíci

    I put my 1991 pro v16 tracker in at the peninsula every week lol. I also have a 40 hp with no power trim. Loaded with 2 men runs a steady 28 mph.

  • @28cruzin
    @28cruzin Před 7 měsíci

    Nice job Benny! The boat came out really nice. I noticed you didn't use the powertrim to get a better top speed. While at speed, trim the motor up. This lifts the front of the boat reducing drag. You might get another 5mph or so. Also set the engine so the cavitation plate above the prop is on plane with the boat bottom. Check your prop to be sure it is cupped along the trailling edge out to the tips. That helps to reduce cavitation and increase speed. I think with these changes you will pick up 8 to 10 mph. Great work! see you on the next one. Dave

  • @randomcol1378
    @randomcol1378 Před 7 měsíci

    Wow that's awesome, I wonder if the spray coming out more on the left is because the prop is turning clockwise, could it be deeper in the water?

    • @kentuckyyankee
      @kentuckyyankee  Před 7 měsíci

      Thanks! The spray was from the depth finder I think.

  • @charlesswart
    @charlesswart Před 7 měsíci

    Nice! when i was 15 this is all i wanted in the world! The prop makes the difference for takeoff --- probably a skiing prop.

    • @kentuckyyankee
      @kentuckyyankee  Před 7 měsíci

      I like the way the prop is set up for sure, I really like this little boat!

    • @user-st5rc9nz4j
      @user-st5rc9nz4j Před měsícem

      Well what prop is it!?

  • @GatesRapes
    @GatesRapes Před 7 měsíci

    Wanna but a 1998 Regal LSR 1900 , Volvo 4.3 with upholstery issues ? Otherwise great boat and it's in Kentucky

  • @ranger178
    @ranger178 Před 7 měsíci

    I like the low floor in that boat I have Crestliner 16 foot with only 20 hp (state lake limits boats to 20hp) but the deck is high I'd rather be lower like that. with one person I can get up to 20 to 22 mph depending on propeller.

    • @kentuckyyankee
      @kentuckyyankee  Před 7 měsíci

      Totally agree with the low floor that's why I got it, I don't like getting up and down from the decks to fish.

  • @theamerican7080
    @theamerican7080 Před 7 měsíci +1

    You ain't gonna get it up on plane with that there trolling motor, KY. 🤣

    • @kentuckyyankee
      @kentuckyyankee  Před 7 měsíci +1

      Guess not... 😂😂

    • @theamerican7080
      @theamerican7080 Před 7 měsíci +2

      @@kentuckyyankee Actually you'll find it more than adequate for trolling in still waters like in coves and on small ponds.

    • @kentuckyyankee
      @kentuckyyankee  Před 7 měsíci +1

      @theamerican7080 That's what I was thinking too, I was out deep can't tell how fast I'm moving.

  • @bayoumike544
    @bayoumike544 Před 7 měsíci

    Stainless steel prop will get you about 3 to 5 mph increase in speed. Also burns less fuel at cruise.

  • @jamiesawyer5102
    @jamiesawyer5102 Před 7 měsíci

    Before watching, I will say 28mph, that is what my 40hp Yamaha normally pushes, although I have hit 30

  • @theamerican7080
    @theamerican7080 Před 7 měsíci

    28 MPH.

  • @churioz26
    @churioz26 Před 7 měsíci

    I guess same top speed as an nc50. 28 mph.

  • @jeramystephens74
    @jeramystephens74 Před 7 měsíci

    Peninsula?

  • @ranger178
    @ranger178 Před 7 měsíci

    hmm boat does not look too heavy id guess about 30 i think your trailer hitch needs some oil LOL

  • @KP-oe8sk
    @KP-oe8sk Před 7 měsíci

    You need a fishing friend to offset!!!! Great video and Job well done!!

    • @kentuckyyankee
      @kentuckyyankee  Před 7 měsíci

      Thank you! Fishing friends aren't hard to find 😂😂