2007 - 2018 Jeep Wrangler JKU Front Speaker Install
Vložit
- čas přidán 27. 08. 2024
- Parts linked in the description below!
Watch a full tutorial as a Jeep Wrangler Unlimited will have a new pair of NVX 6.5" Speakers installed. We will be using the NVX VSP65KIT 6.5" component set. We will show how to install the mid range speaker in the lower dash, and tweeter in the upper dash factory location.
Click here to see the amplifier and subwoofer install video:
• 2007 - 2018 Jeep Wrang...
For the radio install, click here:
• 2011 - 2018 Jeep Wrang...
For the rear tower speaker install, click here:
• 2007 - 2017 Jeep Wrang...
This video applies to Jeep Wrangler models for years 2007, 2008, 2013, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, and 2018. This video also includes removal, wiring, complete installation, and testing.
If you have any questions, leave a comment below! Be sure to like and subscribe!
Parts used in this install (Amazon Associate Paid Links):
*NVX VSP65KIT 6.5" Component Speakers: amzn.to/3qnxv13
*Exact Fit Tweeter Speaker Adapter for 2" cutout: amzn.to/3x0hS25
Disclosure: As an Amazon Associate I earn from qualifying purchases
Parts linked in the description!
Wanted to see the Driver's side install as well. Good video for the passenger side.
Me too. The driver's side isn't as kind as the passenger side. lol
Nobody shows the drivers side
I actually used this video to get at my recirculating actuator that was broke. Once the speaker is out of the way, it was east work to replace it. Thanks!
This might be a stupid question but what about the driver side speaker
This video is pointless without showing how to remove both sides.
Great Video! I finally got this Sub/Tweeter Kit installed and your Video was extremely helpful. These Speakers are a huge improvement compared to the Factory Speakers. I may also upgrade my Soundbar with the exact same Sub/Tweeter Kit.
Great clear vid! Thanks!
Great explanation on where exactly that other bolt on the bottom is 🙄
Super helpful! Thank you!
Ok now the driver side??
Outstanding video.
No driver side install?
Do you not plug in the factory wiring any where that was plugged into the tweeter to begin with? In other words, is the only input into the crossover coming from the mid range speakers wiring? Basically, after the new install, the original tweeter wires are left unplugged right?
Thanks!
Same question
Hey what did you end up doing. Just leaving the wire harness there, no big deal?
How about the drivers side. That one was easy
No mass loading of the box? No polyfil? Does the increased midbass not "pop" in those boxes? My stock system pops regularly...I am about to upgrade and am worried about that. Stock Jeep audio components are the worst of the worst
Great video mate, definitely a good upgrade
What about the driver side install?
Very simlar, except you have to carefully pull the panel back by and to squeeze the speaker box out.
@@bfb3086 LOL
So 6.5 will fit in the front
The tweeter bracket holes are off center, If you turned the bracket 180 degrees would the screws fit in the correct holes?
What did you do with the old tweeter wires?
How many inches of the stock speaker?
So uhhh… what about the freaking driver side there champ?
Do U have to run crossover with stock tweeter? Also what speakers are you using and what’s price
what are the original speakers
Do you use self tapping screws?
Why do all the videos I see only replace the passenger side?
Because the drivers side knee spkr is a bear.
What crossover did you use?? Why no link??
Crossover is included with the component set. And it is linked in the description.
You did the easy said you should’ve did the driver side much harder
Thnx! Why a crossover?? What's its purpose??
It puts the high end frequencies to the tweeter and the mid frequencies to the mid
WHAT IS THE HOLE SIZE THERE? I AM CURRENTLY BUILDING A FULL SYSTEM IN MY 2016 JKU AND I BOUGHT KICKER 6.5" 2 WAY SPEAKERS. IT SEEMS THE SOUNDBAR I NEEDED ADAPTERS TO INSTALL THE SPEAKERS I BOUGHT BECAUSE THEY DID NOT HAVE THE LONG EARS LIKE THE FACTORY ONES. I AM ASSUMING THE HOLE IS TOO BIG FOR STANDARD 6.5"
WILL I NEED A SECONS PAIR OF THE ADAPTER RINGS FOR THE DASH OR NO? IT DIDNT APPEAR YOU DID.
This is a helpful video, but what you don't show is just how much of a bitch it is to get the driver's side speaker box out. No glove compartment hole to go thru on that side!