Freightliner M2 106 Steering Wheel Crooked Align to Center (Deep Socket Needed 30mm or 1 3/16")

Nut was 1 3/16" or 30mm . I torqued the nut to 35 ft lbs that might not be right. It might the closer to 50? Can't find a spec online. Leave a comment if you know.
Of course I found this thread after I had done it myself with some good pics: www.irv2.com/forums/f297/stee...

[@jag524]

You didn't mention it but I assume that when you pull off the steering wheel the shaft is grooved and you just centered the steering wheel and hopefully it aligned with the grooves when positioned correctly.

[@JoshBelowKnee]

Yes, the shaft was splined. Not two flats held with friction. This made it much easier to take off.