I installed fog lights in my 2013 base cab 2wd 5 speed manual and the bezels were already in the bumper, just had to remove the center plug/cover. You can check to see if your Tacoma is prewired and if it is you'll need the dash switch, insert a power fuse and install a set of fog lights; no full kit required. My Tacoma wasn't prewired and I needed a full kit for mine.
Lights are installed upsidedown. Yellow is supposed to be lower. You have left installed on the right side and vice versa. Plus they're aimmed too high.
Luckily you can adjust the beam height. As for being upside down, you can technically swap them but the these have a built in projector lenses. So I would believe the output wouldn't be correct. But I could be mistaken.
That's just how these fogs are. You'll get the white beam aimed and leveled, but once you turn on the yellow, the beam pattern is way high... almost inline with the headlight beams. Going to reach out to AlphaRex today and figure out why.
...this is actually designed right and you have them installed correctly. European yellow fog lights are in lieu of running your headlights. Those guys know about fog! The clear "foglights" are more for added light below where your low beam headlights stop. Also they typically shine some light in the ditch. Looks great. Just ordered a set for my ct200h @loafboi_
Terrible design. Just not a good idea for the beam pattern to change that much when switching between colors. The Diode Dynamics Elite Series fog lights are so much better and built in the USA.
I installed fog lights in my 2013 base cab 2wd 5 speed manual and the bezels were already in the bumper, just had to remove the center plug/cover. You can check to see if your Tacoma is prewired and if it is you'll need the dash switch, insert a power fuse and install a set of fog lights; no full kit required. My Tacoma wasn't prewired and I needed a full kit for mine.
They look great! I might have to consider getting these. Thank you for showing us your install.
I have the alpha rex luxx front and rear lights. I choose amber for my daytime running lights as well. Man they look great 😮😀
Sweet! Just ordered these!
How are these compared to the Baja Designs in terms of brightness?
Oh the Baja are for sure brighter in terms of brightness. Even the SAE version.
Where did you go through the firewall to pull the plug through?
There's a rubber boot on the driver side of the firewall that has wires run through it from the factory. Use that
Bruh these are sold out 😢
Hopefully they come back in stock soon!
Lights are installed upsidedown. Yellow is supposed to be lower. You have left installed on the right side and vice versa. Plus they're aimmed too high.
Luckily you can adjust the beam height. As for being upside down, you can technically swap them but the these have a built in projector lenses. So I would believe the output wouldn't be correct. But I could be mistaken.
That's just how these fogs are. You'll get the white beam aimed and leveled, but once you turn on the yellow, the beam pattern is way high... almost inline with the headlight beams. Going to reach out to AlphaRex today and figure out why.
...this is actually designed right and you have them installed correctly. European yellow fog lights are in lieu of running your headlights. Those guys know about fog!
The clear "foglights" are more for added light below where your low beam headlights stop. Also they typically shine some light in the ditch.
Looks great.
Just ordered a set for my ct200h
@loafboi_
Damn, nice floor
Aim those lights. They’re too high
Terrible design. Just not a good idea for the beam pattern to change that much when switching between colors. The Diode Dynamics Elite Series fog lights are so much better and built in the USA.