Unfortunately no as I dont have a 650 tractor to work on. My video of fixing the rear axle trumpet shows me replacing the inner seal. This tractor doesn't have the collar on the axle like a 650 would for the outer axle seal so I have no video on replacing that one. The inner seal is fairly simple. For it just remove the wheel, and brakes. Then unbolt axle shaft/brake backing plate and slide axle assembly out. Your inner seal will then be right in front of you. The outer seal, on the axle/brake backing plate assembly, you'll have to crack the collar and then remove it and the hub to access the seal. I did them on my 861 years ago and they were a pain. If just leaking rear end oil your inner seal is most likely culprit. You'll also need a press to reinstall the new collar.
Can you tell me what size the holes are in the draw bar bracket ? I can not get to my tractor yet because of snow and I need to get some pins to keep the draw bar from swinging side to side and I don’t know what size of pins I need.
Mine was on backwards from the PO. This video was the only thing I found that showed mine was wrong. Thank you
Good day from Ont. I always think tractor looks a little bigger or heavier Thanks for video.
Great video , can you give some examples of WHY you need a draw bar? What use cases would you need one? Thx!
You use one to pull certain implements such as hay bailers. I don't have any implements that use a drawbar myself. All mine are 3 point hitch.
Hay balers, some hay rakes, wagon, manure spreader... those are just a few I've seen pulled with a drawbar.
Caught you just in time
Have you done a video doing rear axle seal on a ford 650 tractor if not please I need to replace my thank you for the videos
Unfortunately no as I dont have a 650 tractor to work on. My video of fixing the rear axle trumpet shows me replacing the inner seal. This tractor doesn't have the collar on the axle like a 650 would for the outer axle seal so I have no video on replacing that one. The inner seal is fairly simple. For it just remove the wheel, and brakes. Then unbolt axle shaft/brake backing plate and slide axle assembly out. Your inner seal will then be right in front of you. The outer seal, on the axle/brake backing plate assembly, you'll have to crack the collar and then remove it and the hub to access the seal. I did them on my 861 years ago and they were a pain. If just leaking rear end oil your inner seal is most likely culprit. You'll also need a press to reinstall the new collar.
Did you have rear wheels powder coated? If not what did you use? Thanks
They are painted silver. I used a Case color from New holland. Quart can is part number B17565.
Can you tell me what size the holes are in the draw bar bracket ? I can not get to my tractor yet because of snow and I need to get some pins to keep the draw bar from swinging side to side and I don’t know what size of pins I need.
Pretty sure I stuck some 7/16" bolts down into mine to hold it center. I'll check and let you know for sure.
Yes 7/16" bolts about 3" long.
Thank you for spending your time to look for me. I really appreciate it and thank you for your video.
@@markrencher5863 no problem and you're welcome.