Amazing and truly helpful video Jimmy! Thanks for your videos! I cant believe that motorcycle rider kicked that OneWheel Rider and made him wreck! Some people! Be careful and wear your gear against those Jerks!
Great video! I put my one wheel XR Down for the last two years but am looking forward to getting back into it this Spring. Great list and your dog is super CUTE!!
Very timely video for my beginning journey on the Trampa board. Love the finger bell. It will make a great addition to my trail riding experience. Great video as always guys.
New to the OneWheel community, but my board has major ED probably due to my bigger foot size, the furniture pads fixed it no problems and let me float on 💚
I have the hard side of velcro on my pint x to activate the sensors and it also helps w grip. And I find Vessi shoes to be pretty good for riding bc they’re waterproof so they hold in heat really well
Instead of a finger dinner I just used a cheap ring bike bell I got on Amazon for like $4. I 3D printed a little tab for it to stop it from rotating and it works great. I even made a little clip that goes on the bag I have attached to the back of my euc so I can quickly snap it on or off and not have to worry about forgetting it.
Love the opening gag. Unfortunately I don't think the furniture pads would work for someone like me with large feet. I bought the overpriced flat pads, and it's been perfect so far unless I find the small dead zone in the corner where the sensor was slit for the concave pad. I've been looking for a button/speaker combo that I can clip onto me to press for the same purpose as the bell. I don't want to hold something or wrap it around my finger if I can avoid doing so.
Thank you for the video, lots of good products in there. I think I'll pick up the finger dinger for my EUC, because I hate saying 'on your left'. Also, this video reaffirms my view that [some] motorcyclists are a-holes.
Hello .. I’ve been watching your videos for a long time. I messed up my front sensor when trying to replace grip tape on my Pint. How do I remedy this ? The sensors work but there’s a blinking yellow light
I’ve never skateboarded or ridden a Onewheel. They look like so much fun. Do you have a video on people with no experience thinking about purchasing one?
I've been suffering plantar facitis in my right foot, for the last 5 months, due to my time on the Onewheel. I do miss being able to walk without pain. Lol. Don't know if I should have have gotten a better pair of shoes and whether that would have been the difference.
I have that problem too…customs insoles made it feel even more painful. I find if I stop every mile or so for the first 5 miles and massage the soles of my feet and stretch them back and forth the next 5 to 15 miles is a lot less painful. Those vans are definitely worth a shot!
You get someone hurt with these furniture pads man. If it does not engage right without them, it can cutoff at speed as the rider carves or moves around the front.
Not necessarily. It's a redesigned sensor, first time they've done a concave pad and sensor, and they chose a horrible angle for the curve. That same sensor on the flat pad is much better than on the concave. XR and GT are both great boards.
Appreciate the GT footpad hack, but the flat footpads are well worth the investment if concave isn’t working for you. FM really should make that an option upon GT purchase.
ED. Probably one of the best openers I’ve seen in a long time. Well played sir.
Just trying to keep up with you and some of your great openers!
The best, respectable one wheel channel on the tube.
Respect!
Thanks Jimmy for creating and sharing another great video. Glad to see the doggie running along the OneWheel.
LOVE that Finger Dinger concept, even has a groove to stop it rotating too.
Looks like the finger dinger is a hit!
Awesome video, I love the idea of the finger dinger, I always feel awkward saying "on your left" when on bike/hike trails.
You and me both!
Amazing and truly helpful video Jimmy! Thanks for your videos!
I cant believe that motorcycle rider kicked that OneWheel Rider and made him wreck! Some people! Be careful and wear your gear against those Jerks!
Great video! I put my one wheel XR Down for the last two years but am looking forward to getting back into it this Spring. Great list and your dog is super CUTE!!
Very timely video for my beginning journey on the Trampa board. Love the finger bell. It will make a great addition to my trail riding experience. Great video as always guys.
Glad it was helpful!
New to the OneWheel community, but my board has major ED probably due to my bigger foot size, the furniture pads fixed it no problems and let me float on 💚
The ED commercial 😂
Totally Short content worthy
Still awaiting in anticipation for the day when you'll hopefully review a Floatwheel
If the 16c small pads had OW of FloatLife logos, they would probably cost $16 😉
Obviously they would cost somewhere between $0.69 - $4.20
@@TheFloatLife 😂
You had me cackling with the Calcium supps.
I have the hard side of velcro on my pint x to activate the sensors and it also helps w grip. And I find Vessi shoes to be pretty good for riding bc they’re waterproof so they hold in heat really well
Try putting two strips of the hard side of velcro tape, it helps with stability and it does just fine in the rain
I'm surprised how overlooked the dots get. I used rubber o rings under my viper pad but if I was using any other front pad I would use sticky dots.
Instead of a finger dinner I just used a cheap ring bike bell I got on Amazon for like $4. I 3D printed a little tab for it to stop it from rotating and it works great. I even made a little clip that goes on the bag I have attached to the back of my euc so I can quickly snap it on or off and not have to worry about forgetting it.
I'll just use my voice since its free 😌
It’s a fun way to get out there and balance, perfect for getting some wind therapy.
But I can’t get enough of my kaabo wolf king GT
Wind therapy!
Love the opening gag. Unfortunately I don't think the furniture pads would work for someone like me with large feet. I bought the overpriced flat pads, and it's been perfect so far unless I find the small dead zone in the corner where the sensor was slit for the concave pad. I've been looking for a button/speaker combo that I can clip onto me to press for the same purpose as the bell. I don't want to hold something or wrap it around my finger if I can avoid doing so.
Thank you for the video, lots of good products in there. I think I'll pick up the finger dinger for my EUC, because I hate saying 'on your left'. Also, this video reaffirms my view that [some] motorcyclists are a-holes.
Insane
that's a shiny dog, man
Excellent video! Is the float life pad for just the back or for both? I seem to get foot fatigue in both feet.
Hello .. I’ve been watching your videos for a long time. I messed up my front sensor when trying to replace grip tape on my Pint. How do I remedy this ? The sensors work but there’s a blinking yellow light
Demon sells a Flexforce top - i believe you wore it in one of your older reviews - that offers extreme full body protection including collarbone
Where can I get that shirt?
I’ve never skateboarded or ridden a Onewheel. They look like so much fun. Do you have a video on people with no experience thinking about purchasing one?
I never ride without my finger dinger
It is really a vital piece of safety equipment
I use a 2 dollar bike bell from Kmart
I've been suffering plantar facitis in my right foot, for the last 5 months, due to my time on the Onewheel. I do miss being able to walk without pain. Lol. Don't know if I should have have gotten a better pair of shoes and whether that would have been the difference.
I have that problem too…customs insoles made it feel even more painful. I find if I stop every mile or so for the first 5 miles and massage the soles of my feet and stretch them back and forth the next 5 to 15 miles is a lot less painful. Those vans are definitely worth a shot!
⚡👏🏼👏🏼⚡
👍🏾🙏🏾
You should wear Nike SB shoes while riding they are so much more comfy.
I’ll give them a try!
You get someone hurt with these furniture pads man. If it does not engage right without them, it can cutoff at speed as the rider carves or moves around the front.
ED 😂😂
Was there ever any justice for the guy knocked off his one wheel?
No
If you cut the pads smaller they won’t hurt your feet as bad. I’m glad I’m an euc rider now….faster, longer range and safer. Why ride anything else?
I've never had an issue with footpad engagement on my XR, it seems like a much better made product than the newer more expensive GT.
Not necessarily. It's a redesigned sensor, first time they've done a concave pad and sensor, and they chose a horrible angle for the curve. That same sensor on the flat pad is much better than on the concave. XR and GT are both great boards.
Do not supplement with calcium. Take magnesium instead. Look it up.
that was simpleasy
Calcium 🤣🤣🤣
it does the body good!
Appreciate the GT footpad hack, but the flat footpads are well worth the investment if concave isn’t working for you. FM really should make that an option upon GT purchase.