How to change pinion gear on Infraction V2
Vložit
- čas přidán 12. 09. 2024
- If your wondering how to upgrade or change your pinion gear this is the video for you. Just put in the 25 tooth pinion gear. Can't wait to see how fast it will go with this upgrade.
Hope you enjoy the video and make sure to like 👍 and SUBSCRIBE for more upcoming videos.....
Beardown and RC is an independent promotor. I am not directly affiliated with any of the vendors or manufacturers in this video. Beardown and RC is not liable for any damage or loss through the use of products or techniques shown. Use at your own risk. This film is intended for entertainment purposes only.
#2021 #rchobby #rc #rccar #rcfun #rccars #rctruck
~-~~-~~~-~~-~
Please watch: "#Short - reinforce your RC body - Mesh tape and shoe goo"
• #Shorts - reinforce yo...
~-~~-~~~-~~-~
Best how to video I've seen thank you just got a new sub
Thanks for this, I just got my infraction and I was curious to look at how you change the pinion and damn they made it easy to change it compared to other RC cars.
Thanks for the video👍🏻 I just put a 27t pinion on my v2 infraction. Bit scared to take it out now
what was your top speed on it? and do you have stock electronics?? asking i Just got a used infraction. and my first speed runs where like 2 hrs ago. i hit 62mph on it. I will need to get new tires on it.
@@mataflais I got 82mph on the 27t pinion and stock electronics but esc was cutting out. I now have a xlx2😃
@@All-rc804 over 80mph impressive. And with the xlx2 is giving you more speed? Or same but not cutting off? Did u also change the motor?
Crazy these gears aren't greased? Must be a reason? Great vid just swaping my pin over now with your help :)))
dust wil stick to the gears making a grinding paste
You mention if the motor is too tight. How do you know if you have those gears too tight (too close)?
Do you push the motor all the way in?
Are u using high quality tools am sure right
MIP good, Sir
So how are you supposed to change the pinion gear if the 2 top screws DO NOT want to move without drilling from out and screwing up the screws themselves?
Use a torx screw
i had to drill it out lmao
I can't get the screws out! 😢
How you know if the mesh is not to tight?
You want to be able to move the pinion a small amount before it makes contact with the teeth of the spur. An easy way to set it if you don't trust yourself to do it just by feel, is to cut a thick piece of paper narrow enough to be able to put it between the pinion and spur, slide the motor to squeeze the paper between the pinion and spur, once the mesh is set with the paper in between the 2 gears, tighten the motor mount screws, slide out the piece of paper. If you can pull the paper out without tearing it and the paper comes out looking pleated, you should be good to go. I hope that helps, if not feel free to let me know or ask me any other questions you may have.
@@beardownandrc1064 thanks mate gonna try that method :)
You completely skipped the entire part of lining up the mesh on the gears man!
What size is that mount screw.
M4 Hex 20mm long