Creality P Filament Dryer

Creality Official Space Pi Filament Dryer, 360° Hot-Air Heating 3D Printer Filament Dryer Box with Fan, Upgraded Filament Dehydrator Storage Box for 1.75/2.85mm PLA PETG ABS Nylon PA TPU Material
Affiliate Link
amzn.to/3JsjskY

[@MarkManner]

my new one shows different (and expected value) humidity levels, not just 15%, FWIW

[@juanpalomino7043]

the numbers in humedity reading didn't change.. any issues with the sensors?

[@BryonGaskin]

Yeah, I noticed that after I shot the video. I basically did the video showing the operation, which was a clunky. Afterwards I used in production at set at TPU and the humidity rating started to 37% then worked it ways down from there over about 8 hours). I'm not sure if 15% is the default when you start it up every time or just the 1st time. I have the EIBOS one and it seems to monitor humidly regardless if it is powered on or not.