Can you do a video on proper break in procedure on new motor please? Getting ready to do top end on 2004 polaris 600 soon. Converting it to a 700 because i can't get parts for a 600. Thanks buddy!
I start it. Let it idle for 5 minutes. Shut it down. let it cool. run it for 5 minutes at idle again to let the oil flow through the engine. I ride it at half throttle for about 10 miles then slowly increase throttle after.
The 600 and 700 are the same bottom end. the heads are the same. the only difference is the piston size and the jug. Make sure you check the oil decompression ball that its not stuck open or closed. There is a bolt you remove in front of the engine with a spring and a ball. I have a video on it. check oil pressure. It should be around 30 psi. If not check out my video.
Nice, I need this. I'll go to part 1 and start there! Thank you
How do you put the throttle body back together?
Are all the parts, specifically plastics, on an Odes 400 interchangeable with a Honda Rancher 350?
Can you do a video on proper break in procedure on new motor please? Getting ready to do top end on 2004 polaris 600 soon. Converting it to a 700 because i can't get parts for a 600. Thanks buddy!
I start it. Let it idle for 5 minutes. Shut it down. let it cool. run it for 5 minutes at idle again to let the oil flow through the engine. I ride it at half throttle for about 10 miles then slowly increase throttle after.
The 600 and 700 are the same bottom end. the heads are the same. the only difference is the piston size and the jug. Make sure you check the oil decompression ball that its not stuck open or closed. There is a bolt you remove in front of the engine with a spring and a ball. I have a video on it. check oil pressure. It should be around 30 psi. If not check out my video.
czcams.com/video/nV-0niX_bZ4/video.htmlsi=vEvEHmOYtsUWv3BN
Thank you sir! Wish you were closer to me! Best wishes for the rest of 2024!@@TitaniummanGarage