Rear Wheel Bearing Replacement - Nissan 300ZX - Z32

In this episode i change out a rear wheel bearing on the Nissan 300ZX
Parts used:
Tools used:
Floor Jack
Car stands
Breaker Bar
Extension
Ratchet
Socket
Wrench
12 ton H-frame Hydraulic Press
Bearing Separator and Puller
Torque Specs:
Wheel Bearing Lock Nut (152-203 FT-LB)
Break anchor pin Nut (159-224 FT-LB)
Wheel Bearing flange to Knuckle (58-72 FT-LB)
Axle to Diff bolts (25-33 FT-LB)
Rear Caliper to Knuckle bolts (29-38 FT-LB)

[@JoseRodriguez-li7hx]

i’ve been using all of your old vids they help so much ty

[@z32_workshop52]

Glad they have been of use to you. It's one of the reasons I made the videos

[@johnmantione8309]

Good job! Bonus points doing it 100% hand wrenching, I did it once (with an impact assistance!) and decided if I ever had to do it again, I'd buy the hub and wheel bearing assembly rather than fight them apart and back together again

[@z32_workshop52]

Thanks for the Bonus points, i like to prove and show people you can do this work with basic tools most of the time. Plus for the cost of having a shop do the work you can easily buy specialty tools for yourself. On the note of buying the whole assembly, that's really not an option anymore. you can buy the bearing and hub separately and put them together, but the rear hubs for a NA car is expensive over $200 and the TT rear hubs are no longer available.

[@cmibt]

Thanks for the vid

[@z32_workshop52]

Hopefully it helped!

[@Sideswipe1135]

Thanks for these videos, really helps me and the entire z32s community. 🎉

[@z32_workshop52]

That's great to hear. I make the videos for me and everyone else so i know what and how i did it.