Lowrance HDS Instrumentation Setup on V19.1

[@capt.lennymiller6524]

Thanks for the video. I'm trying to set this with my Yamaha and I'm having a lot of trouble. I'm using the Lowrance NMEA2000 wiring for everything from the engine to the Lowrance. I can get gauges on the screen but can't get them to read RPM's, volts, hrs and more. Some people say I need a gateway and some say it's not needed. Did you use a gateway?

[@jw228w]

thanks for this video John
i have Lowrance Carbon with nema wire from my engine to gateway box, then backbone, then displays.
I like the gauge setup you have on the CZcams opening but i cant seem to get that set up .
can you please explain steps to
get gauges on screen?
i have Carbon manual but very little said on this.
thanks
john

[@thedutchfisherman7078]

4:02 if you have questions please drop them below.
And then never answers any....🙄🙄

[@JohnEastonFishTecCharts]

Why not try and add comment rather than whining like a little girl?

[@blandry021]

How do you setup the tilt and trim gauge?

[@roshnish2705]

Hi John , i have 2 fish finders, fs9 & elite 7 hds. The engine data appears on the HDS but a blank screen on the FS unit. The backbone is connected correctly. Please advise what can i do

[@mvcorreia5560]

I’m having the same issue, Lowrance folks are telling me my interface cable is bad.

[@getore100]

Thanks for the video. Do you know if the Elite TI2 has this same feature and can it be used with a Honda outboard?

[@JohnEastonFishTecCharts]

Did you try it?

[@getore100]

@@JohnEastonFishTecCharts thanks for asking. It will be for a while

[@edwardmiu4594]

It is work also on elite TI2 9 inch ?

[@JohnEastonFishTecCharts]

try and let me know

[@chrisoh6627]

What gauges can be put on?

[@JohnEastonFishTecCharts]

too many to answer