2004 Honda Odyssey EX MAP Sensor Cleaning

Tools and materials use in this video:
Honda OEM MAP sensor:
37830-PGK-A01 Sensor Assy., Map $104.04
37835-PGK-A01 M.A.P. Sensor O-Ring $8.35
Philip screw driver
10MM Deep socket with 5" extension and 1/4" drive ratchet
Mass Air Flow Sensor Cleaner
Silicone Lubricant
Clean Rag
Torque: 8.7 foot pounds for 4 bolts on the Engine cover (source Odyssey Repair Manual pg 9-9)
and 1.5 foot pound for MAP sensor screw (source Odyssey Repair Manual pg 11-245)
A bad Manifold Absolute Pressure (MAP) sensor can upset fuel delivery and ignition timing. Depending on your vehicle model, your engine might experience one or more of these performance problems :
1. Rich air-fuel ratio
2. Lean air-fuel ratio
3. Surging, RPM fluctuation
4. Poor fuel economy or gas mileage
5. It won't start
6. Lack of engine power, poor acceleration
7. Stalling
8. Detonation and misfire
9. Higher than normal emissions
10. Hard start/No start
11. Engine misfire
12. Engine pinging
13. Multiple MAP sensor Code
14. Fouled sparkplug, detonation
15. Strong fuel smell
16. Struggling going uphill
17. Check Engine light
18. Limp mode
Here are some trouble codes for this sensor:
P0105: MAP sensor circuit malfunction.
P0106: MAP sensor circuit, range or performance malfunction.
P0107: Circuit, low input.
P0108: MAP sensor circuit, high input.
P0109: MAP sensor circuit, intermittent failure.
Other related codes include P0068,P0069,P1106,P1107,P1129.
My Videos collection:
• Repairs
2010 Civic Repairs:
• Civic
2004 Odyssey Repairs:
• Odyssey
2017 Prius Repairs:
• Prius
Other Repairs (PC,Stove,Dryer...):
• Other repairs

[@robertdaniels5755]

I have an 2004 honda odyssey 3.5 vtec i replaced the valve seals and the iac gasket due too me not knowing that the van went over 60,000 miles without an oil change it was a very big mess im still dealing with.i replaced the starter too.the van has a slight putter that you can feel.would that be the map sensor?

[@davevalinty4293]

Could be dirty sensor, I have to replaced my spark plugs to stop it from sputtering on mine.

[@puppygadget3189]

Is it in the same location on a 2006 you think? Thank you for the great video.

[@hgherb]

Is that the same as the IAT Sensor? Intake air Temperature?

[@williamblanks8500]

no

[@dmitryk7320]

What is the purpose of cleaning MAP sensor?

[@t2brfu67]

Allow the sensor to read more accurately,the dirt can mess with idle and/or injectors...

[@mariomartinez7795]

Hi. I have 2003 it was working good but I washed the engine and now I have poor idle.
Do u think it got moisture? And mess up the sensor

[@t2brfu67]

@@mariomartinez7795 Moisture somewhere it shouldn't have,not necessarily that particular sensor...