Radiomaster MT12 3 Position Switch Programming

Here is my how-to setup a 3-position switch on the Radiomaster MT12 transmitter.
Please Support Your Local Hobbyshop.
Local Hobbyshop I support is Leisure Hours Hobbies: www.leisurehou...
#rc #jeepcj7 #rccrawler #radiocontroltoy #radiocontrolled #reefsrc #rctrailing #remotecontrolcar #remotecontrol #remotecontroltruck #remotecontroltoys #remotecontroltoy #outdoors #offroad #hiking #henrysrcgarage @henrysrcgarage5210 #trending #radiomaster #howto

[@jochenweisel8612]

Your knowledge is insane. Thx

[@henrysrcgarage5210]

Thank You for Watching. Sometimes I do surprise myself in what I'll know in a short time. Hopefully this has help you out.

[@SlavaRC]

🤩💥💯💪😃👍

[@henrysrcgarage5210]

Thank You for Watching! It is much appreciated.

[@ChrisCroft77]

I was wondering why you did it a complicated way but it’s a not a momentary 3 position switch you have setup. I have mine setup as a momentary 3 position switch.

[@henrysrcgarage5210]

Thank You for Watching. When I first got the MT12, I realized Trim 3 and 4, when I was trying to program the overdrive servo on my Phoenix Portal, were momentary and if i did a sticky they were 2 postion. For my overdrive, it gives me a free wheel option and only goes rear wheel drive if I want to with the 3 position trim option.

[@natyvia]

I was wondering how do you adjust the end points on the servo when you do a 3pos switch? I'm using a reefs micro for my dig in my capra and the end points have to be correct or you will burn the servo out

[@henrysrcgarage5210]

Thank You for Watching. I will typically set my end points to zero and work from there till I get the engagement needed. Then I'll leave it in one position and monitor if the servo starts to heat up. Then flip to the opposite and monitor for heat. This is pretty much my process.

[@natyvia]

Can you do a video showing how to set the end points on the Mt12.