Radiomaster MT12 Winch Setup Programming

Here is my how-to setup a Winch setup on the Radiomaster MT12 transmitter.
Please Support Your Local Hobbyshop.
Local Hobbyshop I support is Leisure Hours Hobbies: www.leisurehours.com/
#rc #jeepcj7 #rccrawler #radiocontroltoy #radiocontrolled #reefsrc #rctrailing #remotecontrolcar #remotecontrol #remotecontroltruck #remotecontroltoys #remotecontroltoy #outdoors #offroad #hiking #henrysrcgarage @henrysrcgarage5210 #trending #radiomaster #howto

[@chrisstone8189]

Loving the MT12 content, please keep up the good work !

[@henrysrcgarage5210]

Thank You for Watching and the support the M12 content.

[@tjworsham1272]

Thank you so much for the video! It really helps out because the forums have a lot of stuff to read through.

[@henrysrcgarage5210]

Thank You for Watching. You are welcome and can agree with you on reading through post after post to get a feel of what you are looking. Sometimes it could be hours before you know it.

[@waltsmithiv]

Idk what I’m doing wrong lol. Copied it perfect and I’m not showing anything for channel 5

[@henrysrcgarage5210]

Thank You for Watching. Not sure what the issue could be if you have the 4 in 1 version. I have heard/read a while back in the FB pages where if you have the ELRS version you need to do something in the radio to get other channels to work.

[@Paintscustomcrawlers]

Same I have the 4in1 just like his and have exact setting but on channel 3 and it won’t work

[@henrysrcgarage5210]

@Paintscustomcrawlers thank you for watching. Are you using a winch with an built in controller like the Reefs Rc 422hd winch for example? Make sure the rx connector for it is installed correctly, ground to ground, power to power and signal to signal in the rx ch port. If you are using a rc4wd warn winch, you need the controller to work the winch.
Did you happen to setup the winch exactly like I have it except for ch 3? Did you also happen to have the 2 switches installed on the base of the TX? This is how I'm activating and deactivating it. If so, in the special functions, try unchecking the check box and click return. The winch should work without a switch to activate it.

[@Paintscustomcrawlers]

@@henrysrcgarage5210 I’m using it on a reefs 99 micro winch I had it set up without the switch’s at first and just had it set to t3 but wouldn’t work so I changed to the f2 switch and still nothing. But my controller also won’t let me switch the trim switch’s to 3position switch’s

[@henrysrcgarage5210]

@Paintscustomcrawlers odd you cannot get T3 to work. As far as I know and experienced on mine is any of my T switches once I changed them in drive mode zero from colon zero to dash dash it deactivated them from working as trims. Once I programed mixes on channel 5 to T1+ to positive 100 and T1- to negative 100 it worked as a momentary 3 position switch.
I know on the Reefs servos you need to ensure the gray wire on the servo plug goes to the signal side of the rx. I have flipped it a time or two without realizing and wondered why it was not working.
I am also wondering is if I'm on a newer version of the firmware right out of the box. I have heard some of the earlier ones were on an older version then what I have. I'm on firmware version 2.10 if I recall.