Siemens V90 Servo set up in TIA portal communications with S7-1500/1200 PLC

[@mohammedrezk8072]

So great videos tutorial,keep it up.

[@framos9991]

Thank you!!!

[@saulosouza5494]

Thanks, you got a new subscriber

[@zikoaouffou6389]

I HAVE a question about the choosen telegram 3 . as i read from siemens help the telegram 3 doesnt support the IRT it only support RT but why you choose the isonchrounous mode in the paramaeters ? i think you should select telegram 5 or 105

[@tehseenarshad8602]

Thanks Sir

[@farhadkhorasani4625]

Thanks

[@adelcarrillo3552]

Hello, I appreciate a lot you rvideo. However I have a problem when I try to comissioning since tia portal: however the telegram is not being sent and the error on servodrive is: F8501: PROFIdrive: Time
exceeded setpoint
Reaction: OFF3
Confirmation: IMMEDIATELY
Receiving PROFINET setpoints
has been interrupted.
• The PROFINET connection has been interrupted.
• Controller disconnected.
• Controller set to state
STOP.
• PROFINET defective.
Restore the PROFINET connection and set the controller to R state. tHE COMM led is okay but RUN led is blinking red. The shyncronous is okay. Do you have Any idea to fix It? Thank you very much.

[@robindc2630]

nojb