Siemens V90 servo drive wiring, set up, auto tune and configuration using Vassist. Eng

Siemens V90 servo drive wiring, set up, auto tune and configuration using V Assist. Please see helpful manuals from seimens below.
TIA portal setup: cache.industry...
V90 Manula: cache.industry...

[@EdgarEstoesta]

Thank you boss IGS for your videos this were help us beginners big and to encourage to do more and think big, thank you very much Boss....

[@tehseenarshad8602]

thanks boss

[@framos9991]

Thanks!

[@augustinmarker3444]

i noticed you never used the setpoint cable i am new to this, is profinet cable sufficient? or do we have to connect seperate pto outputs as well

[@ahmedzm8029]

I have one question, when we do an autotune, should we do that with or without load?

[@nomandanish441]

Great

[@TomSmith-eq1vr]

Your videos have been very informativ and a massive help.
I am looking at building an automated machine using mainly siemens parts.
Will need a siemens PLC to drive a 1.2kw Servo, a 2.2kw sew Euro drive 3phase geared motor and VFD and a HMI to control the whole show alone with some push buttons.
Could you steer me in the right direction to choosing the correct siemens PLC.

[@IGSElectronics]

Hi Tom. It all depends on complexity of the project. If the project is just turn things on, have some basic logic, with basic functions, no complex data collection, analysis , calculations and so on, a basic Logo would do. Logo can do a lot for such a small an cheep controller.

[@thomassaook7787]

Great work, how can I be a part of your team?

[@vc-go48]

Why can't I connect to ethernet at vstant connection?

[@user-iq5kd6mg3f]

good morning, please are you on LinkedIn