Got Lift Scrub? - Toyota Tundra Fender Liner Molding and Mud Flap Trim
Vložit
- čas přidán 22. 04. 2019
- After installing the 3 inch lift kit and 34 inch tires there was a slight rub in the front end on the plastic fender liners and mud flaps. In this video I'm using heat to mold the liners and cut sections of the mud flaps out with a knife. Thanks for watching.
Heat Gun
amzn.to/3kfwV3f
Milwaukee Utility Knife
amzn.to/3LcxhDw
Pry Tools
amzn.to/3vfwuw2
Metric Socket Set
amzn.to/3vDAfue
Pick Tool Set
amzn.to/3MAmcwx
As an Amazon affiliate, I earn from qualifying purchases. All the proceeds go towards keeping the channel alive and well. Thanks! - Auta a dopravní prostředky
I am in the process of adding a pre runner NFAB MBRS bumper in the front and going to 34's on a 2.75 lift with Bilstein 6112's in the front. I already removed both my mud flaps... Hoping no rub.. we will see. Thanks for the vid
Heck yea, that sounds good. I really like the look of NFAB bumpers.
George Vannet any update on the rubbing?
@@cpwned I have a very small amount of rubbing on the plastic while in reverse at full turn either direction. I think this could be corrected with a different offset on the wheel. My wheels and tires stick out past the fender approximately 2 inches. If I reduced that I think the truck wouldn't rub. Either way, the rubbing is so minimal that I don't notice it.
GoatsInAPond thanks for the reply!!
Good work...what tire size are you running...just ordered some 34.8s, will most likely have to trim some pieces.
In this video I'm running 34s. I put 35s on later and had to do more trimming. The metal cab mounts had to be grinded down.
Any update? What size tires are you running?
I had to trim more on the mud flaps because the tires rubbed in reverse. The front molded section provided enough clearance. My tires are size 275/65 with a 3/1 lift.
What rims do you have ?
Fuel Vector in Anthracite
What rims are those
Fuel Vector in Anthracite