LEHLE DUAL EXPRESSION and Neural Quad Cortex - quick setup
Vložit
- čas přidán 12. 04. 2023
- Does the LEHLE DUAL EXPRESSION work with the Neural Quad Cortex? Yes, but how does the switch work?
We teamed up with Simon Schneid, who did a quick demo and shows how to set up the connections and settings, so you can easily switch between VOL and WAH. Or anything else!
www.expression-pedal.com
www.linktr.ee/simonschneidcom - Hudba
This is a great demo, I just wanted to check one thing. So when you push down on the toe part (like you would on a wah with a switch), it can activate a different effect? So you can have it set up as a volume pedal, but then kick on and off a wah (or any other effect) too?
As shown in the video, you can use the expression for anything. Then triggered by the switch of the 10K socket, the QC can activate module X and deactivate module Y. The videos just shows an application which is handy.
Just so I haven't misunderstood, the reason you are using the two outputs from the Lehle is that the 10K is acting as a switch? and the 50K is for the Volume AND the Wah and you switch between the two with the 10K configured as a switch? OR does the Lehle have a switch function in addition to the 10K and 50K?
Basically - yes. In this particular case the 50K is the socket you use to manipulate the expression with (which can be then vol, wah, mix of a delay, whatsoever in your QC) and the 10K is configured as a switching socket, which toggles a function at the QC.
@@LehleSwitcher My use case would be that I want to use this expression pedal to control two parameters of the same QC effect/block independently - meaning that I would like to switch between expression 1 and expression 2. When I try to calibrate the pedal in QC or try different setting on Lehle it always controls two parameters at once instead of switching between 1 and 2. How can I solve my problem?
@@DG-km3el Sorry, but we can't help - I think this is a case for @NeuralDSP support
I hve set this as well but my problem is that the expression pedal direclty switch to wah in case I put volume to max and dont press the dual expression hard. Even with my hand it switch to wah and visa versa. How can I improve that?
No problem! The point where the switch trigger, can be calibrated.
Simple take a look at the manual and calibrate the pedal or write us mail.
I have the same problem even after calibration. Did you solve the problem?
@@tanggenius3371 no I didn’t
Can you make video how to calibrate the dual expression so it will not switch when I use it manually, so only when you push it by your foot
Did you solve it? I would like this one if it works properly.
It can be used as volume pedal?
It's an expression pedal and can control functions in a device, such as a volume function in the QC.
However, one can not send audio signal through an expression pedal.