Bennche Spire 800 motor tear down (Odes, Massimo, HiSun)

Well here is part #2 of the 2012 Bennche spire 800 complete motor tear down. This motor is the same in the Odes, Massimo, Hisun 800s. If you need to get a hold of me with questions about Motorcycles, Atvs, Utvs leave a comment, find me on FB at Limitless Powersports service & repair are you can email me at [e-mail]

[@a.c.m.e.ink.4568]

My Dad once loaned a trailer to an Uncle. All that came back, was the axle & running gear. The rest was M.I.A !!

[@GordGoral]

Kyle. Any idea as to when part 3 will be posted? Thanks

[@limitlesspowersportsservic3394]

I'm in the process of editing it. I might break up the series of building the motor into two parts because right now the full motor build video is going to be over 2 hours long

[@GordGoral]

Kyle. Is the flywheel puller thread size M38 x 1.5 right hand? I found some of these on Amazon. How are the crank shaft bearing halves removed and installed ? is there a special tool? Thanks

[@limitlesspowersportsservic3394]

Yes it's 38mx1.50 right hand thread. Here is my affiliate link.amzn.to/3K5uvRv also getting the crank case bearings out I bought the can am bearing remover & installer tool from the canampartsguy.com it was $100. Part 3 will be out next week when I get the proper crankcase gasket in showing all the tools & how too

[@martintinus5678]

hi, i have the same engine and a problem i can´t figure out. i´ve to rebuild it cause the rod bearings were gone. new crankshaft new cylinders/pistons etc. put everything together and now cylinder 1 has only 137 psi compression cylinder 2 is fine. i thoght the cylinderhead / valves were faulty so i replaced the head with new valves but still the same. Do you have any idea ?

[@limitlesspowersportsservic3394]

Did you check the piston ring end gap to make sure it was with in spec? Also put a little bit of oil into the cylinder & if the compression goes up it's a ring problem. But a leak doing test will tell you were the issue is.

[@a.c.m.e.ink.4568]

'Loaned' your flywheel puller to a buddy. But you can 'maybe borrow' one from a buddy ! 🤔🤨😂Possibly the 'same' buddy???!

[@limitlesspowersportsservic3394]

🤣🤣 I wish it was.